AgriProTech AviTrac Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt rolniczy AgriProTech AviTrac. AgriProTech AviTrac 15 stron. Solar panel option
Również dla AgriProTech AviTrac: Podręcznik użytkownika (8 strony)

Drukuj stronę

IV - Programming

1. Screen and keyboard

The AviTrac® acoustic bird repeller is programmed via its

screen and its two buttons. The 2 buttons are named Select

and OK (Picture 13).

2. Switching on the device

The activation of scaring signals can be programmed in two ways:

a. With the "programmable" alarm, you can choose the start and end times of sound emissions.

b. With the "luminosity" alarm, the signals activate at sunrise and stop at the end of the day,

thanks to the luminosity sensor on the electronic module.

Caution: To avoid the emission of unwanted sound signals, it is important to choose ONE alarm: either the

"programmable" alarm or the "luminosity" alarm.

To start programming the device, press and hold the OK button for 4 seconds (until the AviTrac® screen lights

up). You can access the menu quickly by pressing the OK button again. Information about the device

identification (version of the device and software) appears. You can switch back from this screen by pressing

on the OK button again.

The "Menu" screen appears and indicates if the "programmable"

(a. in the picture opposite) and "luminosity" alarms (b. in the

picture opposite) are active or inactive. Once in the "Home" menu,

press the Select button to browse between the different

programming pages.

The first "Status" screen gives you the following information on

your AviTrac® device:

 Whether the memory card is inserted or not

 Battery level in %

 Battery level in mV

 Luminosity in mV

You can press the Select button again to close this screen and browse the following menus.

Hint:



When browsing through the different menus, you can return to the Home menu by holding down the

Select button for a few seconds.



To stop a signal which is currently being emitted, just press the OK button.

[email protected]

– Tel: +33 (0)2 98 96 08 12 -

Picture 13 Select and OK buttons