Hiesbok Hawk Instrukcje budowania

Przeglądaj online lub pobierz pdf Instrukcje budowania dla Zabawka Hiesbok Hawk. Hiesbok Hawk 3 stron. Glider

HAWK

GLIDER BUILDING INSTRUCTIONS

Thank you for purchasing this HAWK model glider kit. The kit has been manufactured using the latest

CNC laser technology and all parts have been clearly labelled and can be cross referenced to the plans.

The Hawk model is designed as a simple multi-purpose, easy-build glider. It can be built in several

configurations including a free-flight chuck glider with a choice of two different wing styles or RC model

with micro servos (not included).

You can quickly and easily test the effect of adjusting ailerons, flaps, rudder and elevator on the flight

characteristics of the model. This is facilitated using flexible wire hinges on each of the control surfaces.

To start construction, you will need a straight, flat worktop, modelling pins, sandpaper, glue (we

recommend using thin Cyanoacrylate (CA) glue or Super 'Phatic adhesive, available from Deluxe

Materials in the UK at www.deluxematerials.co.uk). Your choice of paint can also be applied to

customise the model but use sparingly as this will add weight to your model.

In these instructions we describe the basic building steps required to complete the model. If necessary,

please consult the help and advice of someone who has the acquired skills required to complete the

model.

The nose section of the fuselage, comprising parts 5,6,7 & 8, has been taped together in the correct

sequence of assembly. Carefully remove the tape keeping the parts in the same sequence for gluing

together.

Next, cut two 12mm lengths of dowel and chamfer the ends. These dowels (part 4) are inserted into the

predrilled holes in the nose sections, parts 5,6 & 7 to align the parts whilst gluing together.

Note: Due to possible variations in the diameter of the dowel material, it may be necessary to lightly

sand the outside diameter to reduce their size to accurately fit the holes.

Do NOT stick the 14mm dowels in place.

Once assembled and glued, allow the nose section to fully set on a flat surface. Secure with pins if

necessary.