Aire Magnitude 34348 Instrukcja obsługi Certyfikat gwarancyjny - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi Certyfikat gwarancyjny dla Wentylator Aire Magnitude 34348. Aire Magnitude 34348 17 stron.

HANGING THE FAN-CLOSE-TO-CEILING MOUNTING

WARNING: All of the parts, hardware and components such as the hanger bracket and hanger ball have been provided

for your safety and the proper installation of your new ceiling fan. The use of other parts, hardware or components not

supplied by Aire with the fan will void the Aire Warranty.

REMEMBER to turn off the power. Follow the steps below to hang your fan properly:

Step 1. Remove the canopy ring from the canopy by turning the canopy ring counterclockwise. Remove the mounting

bracket from the canopy by loosening the four screws on the top of the canopy. Remove the two non-slotted screws and

loosen the slotted screws. (Figure 14)

Step 2. Remove the decorative canopy bottom cover from the canopy by turning the canopy bottom cover

counterclockwise. (Figure 15)

Step 3. Pass the 120-volt supply wires through the center hole in the mounting bracket. Attach the mounting bracket on

the outlet box by sliding the mounting bracket over the screws provided with the outlet box. When using

"close-to-ceiling" mounting, it is important that the mounting bracket be level. If necessary, use leveling washers (not

included) between the mounting bracket and the outlet box. Note that the ﬂat side of the mounting bracket is toward the

outlet box. (Figure 16)

Step 4. Route the wires exiting the top of the fan motor through the canopy. Then proceed to place the ceiling canopy

over the collar at the top of the motor. Align the mounting holes with the holes in the motor and fasten using the screws

and lock washers provided. (Figure 17)

Step 5. Hang the fan on the hook of the hanger bracket. Be certain that the canopy is fully locked into hook as shown in

Figure 18.

LOOSEN

BUT DO NOT

REMOVE

CANOPY RING

FIG. 14

REMOVE

CANOPY

FIG. 15

SCREW AND

LOCKWASHER

CANOPY

RING

COLLAR

FIG. 17

CANOPY

BOTTOM

COVER

HOOK

FIG. 18

OUTLET BOX

HANGER BRACKET

FIG. 16