8STREME 5200-J2X Podręcznik - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik dla Odkurzacz basenowy 8STREME 5200-J2X. 8STREME 5200-J2X 16 stron. Robotic pool cleaner
Również dla 8STREME 5200-J2X: Podręcznik (16 strony)

Drukuj stronę
8STREME 5200-J2X Podręcznik
EN
The robot moves in one direction
The robot does not move and the filtration pump
does not work either. The robot doesn't work any
longer.
The pump runs but the robot does not move. The
robot turns on but stays on the spot.
The robot stops after a few minutes
- An object blocks the rollers, the wheels of the robot
or interfering with the movement of the robot.
- The robot is not connected to a power source.
- Power off
- No / not enough power is transmitted to the robot
- An object blocks the rollers,.
- Possibility of motor problem
- Connection of the floating cable
- Possibility of fault of the floating cable
- Possibility of motor leakage
- Unplug power supply and take robot out of water.
Open the cleaner to inspect the cleaner.
- Check that there are no foreign objects in the
impellers.
- Check that there are no foreign object blocking the
rollers located below the cleaner.
- Check that the power source is active by plugging
another device into the power outlet.
- Check that the power supply is turned on.
- Check all connections of the robot to the power
source.
- Check that there are no foreign objects in the
impellers.
- Unplug the power and take out the robot in the
water. Open the cover of the basket and remove the
basket.
- Check that there are no foreign objects in the
impellers.
- Check that there are no foreign object blocking the
rollers located below the cleaner.
- Contact the After-sales Service
- Check the connection of the floating cable.
Disconnect and reconnect as needed.
- Check the status of the connectors at the ends of
your cables (damaged, rusted, etc.)
PROBLEM
CAUS E(S)
SOLUTION(S)
The robot moves slower than before
- The robot is too heavy
- The flow is not sufficient
- Cables connections
- Check the bag and clean it if necessary.
- Check that there are no foreign objects in the
impellers.
- Check that there are no foreign object blocking the
rollers located below the cleaner.
- Check the status of the connectors at the ends of
your cables (damaged, rusted, etc.)
Page 12