Hifionics Hifonics TXi15080 Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Hifionics Hifonics TXi15080. Hifionics Hifonics TXi15080 15 stron. Titan series high performance amplifiers
Drukuj stronę- 1. Table of Contents
- 2. General Installation Procedure
- 3. Amplifier Feature Descriptions
- 4. Txi4008 / Txi6008 2-CHANNEL AMPLIFIER APPLICATIONS
- 5. Txi4408 / Txi6408 4 -CHANNEL AMPLIFIER APPLICATIONS
- 6. Txi7508 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
- 7. Txi1008D / Txi1508D D CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
- 8. Features and Specifications
- 9. Setting up Systems after Installation for Best Performance
- 10. Troubleshooting and Diagnostics
- 11. Product Warranty
TXi4408 / TXi6408 4 CHANNEL AMPLIFIER APPLICATIONS
2 way active, or bi-amplified system with mono bass
This application shows how easily a 2 way active system can be implemented using a 4
channel amplifier. Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono
bass.
Interconnect cable checklist:
- We need to feed the same signal to both sets of channels, so must use a Y-adapter as
shown.
Mono bass woofer wiring:
- Connect the mono speaker positive terminal to the LEFT +, and its negative terminal to
RIGHT -.
Switch setting checklist:
- 1/2CH X-OVER: HP
- 3/4CH X-OVER: LP
Crossover frequency control checklist:
Channels 1/2:
- HI PASS: 100 Hz
- LOW PASS: N/A
MONO INPUT
CHANNELS
3 AND 4
FULL RANGE
STEREO INPUT
CHANNELS
1 AND 2
2 way active, or bi-amplified system with mono bass, and faded highs/lows
Here we present a variation of the previous system. Since this is a 2 way system, we can
use the front outputs from a head unit to drive the highs, and the rear output to drive the
bass This method allows the listener to easily adjust the relative levels of bass to highs,
with the front to rear fade on the head unit.
Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.
FULL RANGE
STEREO LINE
INPUTS
6
Channels 3/4:
- HI PASS (subsonic): 20 Hz
- LOW PASS: 100 Hz
Please note that these frequency points are suggestions only. Refer to the loudspeaker
manufacturer specifications and the section "Setting up systems after installation for best
performance"
Level control checklist:
Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedances:
- 2-Ohms per channel in stereo mode.
- 4-Ohms mono bridged.
Interconnect cable checklist:
- Use good quality RCA leads to connect the inputs of the amplifier to the source as shown.
- Follow the instructions as per the previous system for switch and crossover settings.
MONO
BASS
SPEAKER
TO BATTERY + 12 Volts VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
STEREO
HIGHS
SPEAKERS
MONO
BASS
SPEAKER
TO BATTERY + 12 Volts VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
STEREO
HIGHS
SPEAKERS