Cell2 SAF101H Instrukcja instalacji i obsługi dla użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla użytkownika dla System bezpieczeństwa Cell2 SAF101H. Cell2 SAF101H 6 stron. Electronic handheld siren 12/24vdc

Drukuj stronę

WIRING

Use wires that are capable of handling the required current. Route the wires properly to

prevent wear, overheating and interference with air bag deployment. Ensure that all

connections are tight and double check wiring before connecting to the vehicle battery.

ELECTRICAL CONNECTIONS

Electrical connections to the unit are made by using block plugs and screw terminals.

Route all wiring to the siren and secure onto block plug terminals, then plug onto the

siren. The plug can be easily removed without unwiring when the unit requires servicing.

The power supply for the fused amplifier (12-P plug) must be capable of delivering peak

currents up to12A for adequate short circuit protection and proper operation. It is

recommended to wire directly to the vehicle battery.

WARNING: Ensure that all wires are firmly secured onto the block plug, and plug is firmly

secured onto the siren.

Wire Size and Termination – The "AMPLIFIER CONNECTIONS" diagram shows the

minimum size of the wires used for each connection, along with recommended lead

color. If the wire is longer than 10 ft., use the next larger size.

SW1 (SW1) Output Connection – Connect to auxiliary device power up to 0.2 Amps

max. or use as Lightbar function activation switch.

SW2 (SW2) Output Connection – Connect to auxiliary device power up to 0.2 Amps

max. or use as Lightbar function activation switch.

SW3 (SW3) Output Connection – Connect to auxiliary device power up to 0.2 Amps

max. or use as Lightbar function activation switch.

SW4 (LIGHT) Output Connection – Connect to auxiliary device power up to 0.2 Amps

max. or use as Lightbar function activation switch.

IGN (Ignition) Input Connection – This serves as the power switch for the entire unit.

Connect to a positive circuit controlled by the vehicle ignition switch, usually a terminal at

the vehicle fuse panel. It is not recommended to make permanent power connection as

this may drain battery.

RAD (Radio) Input Connection – Connect to radio output terminals or its speaker.

HORN Input Connection – The Horn Ring Transfer input allows activation by an

external source of the Air Horn function.

Speaker Output Connection – Both connections must be used. Two speakers may be

connected in parallel.

SAF101H Siren_v.1.0

- 4 -

CONNECTIONS

Automotive Type Fuse

12VDC Use15A

12-P Terminal Block Plug

24VDC Use10A

The leads and

recommended

colours shown

are user-supplied.

Recommended

Wire Size

Amps

Size

5-10

#16

10-15

#14

15-25

#12

25-40

#10

40-60

Use next larger size

if longer than 10ft.

Hand held controller

Button Decal

Button Plate

NOTE: The controller is shipped without any button

plates or decals installed. Place decal onto button

plates, then install plates onto each button.

#18 AWG BRN x2

HORN Input Connection

+VDC

HORN

+VDC Switching example

#22 AWG YELLOW

RAD (Radio) Input Connection

#22 AWG GRAY x2 Connect to output

jack, terminals, or speaker of radio

IGN (Ignition) Input Connection

#22 AWG ORG

Unit Enable (like an ON/OFF switch)

Connect to positive circuit (fuse panel)

controlled by ignition or other switch

#14 AWG BLK

#14 AWG RED

- 5 -

SAF101H Siren_v.1.0