Galanz DWIUK001 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Galanz DWIUK001. Galanz DWIUK001 13 stron.

Drukuj stronę

Before Calling the customer helpline

Reviewing the charts on the following pages may make you be free of calling for service.

Possible Causes

Problem

Fuse blown, or the

circuit breaker

activated.

Power supply is

Dishwasher

not turned on

doesn't run

Water pressure

is low

Drain pump

Overflow

doesn't stop

Some audible

sounds are normal

Utensils are not

secure in the

baskets or

Ensure everything is secured in the dishwasher

Noise

something small

has dropped into

the basket

Motor hums

Improper detergent

Suds in

the tub

Spilled rinse agent

Detergent with

Stained tub

colourant was used

interior

Improper programme

Dishes and

flatware

Improper basket

not clean

1 Extremely hard

water

2 Low inlet

temperature

3 Overloading the

Spots and

dishwasher

filming on

4 Improper loading

glasses and

5 Old or damp

flatware

powder detergent

6 Empty rinse agent

dispenser

7 Incorrect dosage

of detergent

What To Do

Replace fuse or reset circuit breaker. Remove any other

appliances sharing the same circuit with the dishwasher.

Make sure the dishwasher is turned on and the door is

closed securely. Make sure the power cord is properly

plugged into the wall socket.

Check that the water supply is properly connected and

the water is turned on.

The system is designed to detect an overflow. When it

does, it shuts off the circulation pump and turns on the

drain pump.

Sound from detergent cup opening.

Dishwasher has not been used regularly. If you do not

use it often, remember to set it to fill and pump out

every week, which will help keep the seal moist.

Only use the recommended dishwasher detergent to

avoid suds. If this occurs, open the dishwasher and let

suds evaporate. Add 1 gallon of cold water to the tub.

Close and latch the dishwasher , then start the "pre-rinse"

wash cycle to drain out the water ... Repeat if necessary

Always wipe up rinse agent spills immediately.

Make sure that the detergent is one without colourant.

Select a stronger programme.

Make sure that the action of the detergent dispenser

and spray arms are not blocked by large dishware.

To remove spots from glassware:

1 Remove all metal utensils out of the dishwasher.

2 Do not add detergent.

3 Choose the longest cycle.

4 Start the dishwasher and allow it to run for about

18 to 22 minutes, then it will be in the main wash.

5 Open the door to pour 2 cups of white vinegar

into the bottom of the dishwasher.

6 Close the door and let the dishwasher complete

the cycle. If the vinegar does not work: Repeat

as above, using 1/4 cup (60 ml) of citric acid

crystals instead of vinegar.

Cloudiness

on glassware

Yellow or

brown film

on inside

surfaces

White film

on inside

surface

The Detergent

dispenser lid

cannot be

closed properly

Detergent left

in dispenser

cups

Steam

Black or

gray marks

on dishes

Water

standing on

the bottom

of the tub

Dishwasher

leaks

Combination of soft

Use less detergent if you have soft water and select a

water and too much

shorter cycle to wash the glassware and to get them

detergent

clean.

Use a solution of 1/2 cup of bleach and 3 cups of

warm water to remove the stains by hand.

WARNING

Tea or coffee stains

You have to wait for 20 minutes after a cycle to let the

heating elements cool down before cleaning interior;

otherwise, burns will happen.

Iron deposits in

water can cause

Contact a water softener company for further advise.

an overall film

To clean the interior, use a damp sponge with

dishwasher detergent and wear rubber gloves. Never

Hard water minerals

use any other cleaner than dishwasher detergent to

avoid foaming or suds.

Clogged detergent

residue is blocking

Clean the detergent from the catch.

the catch

Dishes block

Re-load the dishes properly.

detergent Cups

Steam coming through the vent by the

Normal phenomenon

door latch during drying and water draining.

Aluminum utensils

have rubbed

Use a mild abrasive cleaner to eliminate those marks.

against dishes

A small amount of clean water around the outlet on

This is normal

the tub bottom keeps the water seal lubricated.

Be careful not to overfill the rinse aid dispenser. Spilled

Overfill dispenser or

rinse aid could cause excessive foaming and lead

rinse aid spills

to overflowing. Wipe away any spills with a damp cloth.

Dishwasher

Make sure the dishwasher is level.

isn't level