Dynamo Power DPX7500 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator Dynamo Power DPX7500. Dynamo Power DPX7500 13 stron. Diesel generator

DPX7500 DIESEL GENERATOR

2-6 Proper operation of the generator

2-6.1 Operating the diesel engine

1. Pre-heat the diesel engine for 3

minutes under no load conditions.

2. First check the height of the

lubricating oil level, if it is

low, refill it. Our diesel

engines are equipped with

an oil switch that will

notify you if the oil pressure

is too low. The system will

shut down the engine if the oil

pressures too low.

3. Do not adjust the speed limit

regulation bolt or the fuel adjustment

bolt.These bolts have been set by the

factory already, changing them will affect the properties of the engine

performance.

2-6.2 Checks during engine operation

1. Check to see if there are abnormal noises.

2. Check to see if the performance is good or bad

3. Check the color of the exhaust gases (whether it is too black or too white).

If any of these conditions exist, stop the engine and find the cause of the

problem. If no problems are found, please contact your local dealer or our

nearest company branch.

2-7.1 Load conditions

Exert loads in accordance with the specified parameters.

2-7.2 Output of electricity

1. Raise the revolutions per minute (turn the speed handle to the max setting) of the

generator to get the maximum power out of the generator. If not, the

automatic voltage regulator device will excite and doing this for long periods of time

will cause the AVR to burn. For the rated speed of the generator, please refer to

Chapter 1, item 1-1 technical specification and data.

2. Observe the pointer of the voltmeter, it should point to 240 (60Hz). Meanwhile

put the switch in the GEN (generator) position. The AC voltage from the socket of

the power supply can be output.

3. When connecting devices to the generator, make sure to connect these devices in order.