909 LS1620 Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie 909 LS1620. 909 LS1620 15 stron. 125w 50mm variable speed scroll saw with work light
Drukuj stronęTurning on and off
1. To turn on the scroll saw press the green On (I) button (1).
2. To turn off the scroll saw press the red Off (O) button (1).
Sawdust blower
Your scroll saw features a
sawdust blower (3) to help keep
the work area clean for more
accurate scroll cuts. The blower
tube is fully adjustable and can
be directed as required.
Flexible worklight
The flexible light will illuminate
the work area for greater visibility
of the cutting line.
1. The light will illuminate when
ever the saw is turned on by
pushing the green button (1).
The light cannot be operated
without the saw running
Mitre gauge
The table of the saw is provided
with a guide slot for the operation
of a mitre gauge.
The gauge can be set between
0° and 45°, left or right
1. To adjust, loosen the locking
screw and rotate the gauge
to the desired angle. Lock the
screw at the correct angle.
Note.
Always take a trial cut to ensure the angle is the
correct angle required as the scale is only a guide.
The mitre gauge is particularly suited for cutting angles
which are required to be straight. However, it should be
noted that the cutting action of the blade will not provide
a perfectly flat surface and should be considered on two
mating surfaces.
Adjusting the speed
The speed can be adjusted to suit the workpiece being cut.
The variable speed dial (2) is located on the lower front
panel of the saw, next to the
On/Off buttons, for convenient
adjustment of the speed.
1. Turn the saw on.
2. Turn the dial in a clockwise
direction for a faster speed
and in an anti-clockwise
direction to reduce the speed.
12