909 10CSMS Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła 909 10CSMS. 909 10CSMS 20 stron. 15 amp 10" 254mm single bevel laser guided slide miter saw

Drukuj stronę

Dust bag

The dust bag (14) fits over

the dust extraction port (26).

For more efficient operation,

empty the dust bag when it

is no more than half full. This

allows better air flow through

the bag (Fig. K).

Attaching

the side bars

The side support bars (34)

help to support the material

when working with long

workpieces. There are two

location holes (35) for a

support bar on either side of

the table. Loosen the lock

screws (36) with the 6mm

hex key. Ensure the side bars

are fully inserted before using

them to support the workpiece

(Fig. L).

The side support bar locking

screws (36) must be tightened

to secure the support bars in

position (Fig. M).

Trench depth

adjustment

In its normal position, the

trenching stop (30) permits

the saw blade to cut right

through a workpiece. When

the saw arm is lifted, the

trenching stop can be moved

to the left so that the trenching

depth adjustment screw (29)

contacts the stop as the saw

arm is lowered. (Fig. N).

This restricts the cut to a "trench" in the workpiece. The

depth of the trench can be adjusted with the trenching depth

adjustment screw (29) (Fig. O) and locked in position with

the trenching depth lock nut (31) (Fig. P).

Turning on and off

1. Pull in switch trigger to start

the unit (Fig. Q).

2. To turn the saw off release

the on/off trigger switch (23).

Turning on the

laser line generator

The laser line generator emits

a single beam of pure red

light to guide you as

you cut. It improves operator

cutting vision, enables faster

set-up, increases accuracy

and improves safety. To turn

on the laser lines press the

laser light on/off switch (2)

(Fig. R). To turn off the laser

press the laser light on/off

switch (2) one more time.