909 909210TS Instrukcja obsługi - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła 909 909210TS. 909 909210TS 18 stron. 1200w 210mm 8" table saw
Drukuj stronęCAUTION.
Take note of the running direction. The cutting
edge of the teeth has to point in the running direction, i.e.
forward (see the arrow on the saw blade and guard).
11. Re-fit and re-set the riving knife and the saw blade
guard.
12. Before using the saw again, check that all safety
devices are in good working order.
IMPORTANT.
After replacing the saw blade, make sure the
saw blade runs freely by turning the blade by hand.
13. Plug the machine into a mains socket and run the saw
at no load before using it to cut any materials.
Maintenance
1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a rag or a soft brush. Wear safety glasses whilst
brushing away dust and dirt.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the
plastic parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Only an authorised service centre should replace the
cordset or drivebelt or effect other repairs. If the cordset
is damaged or worn, have it repaired or replaced by an
authorised service centre.
The unit is fitted with an over load protection device. If the
overload is initiated, Switch the unit OFF at the mains, wait
for the unit to cool down. Inspect for any damage. Switch
the unit back ON.
17