Galaxy DX-33HP Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Transceiver Galaxy DX-33HP. Galaxy DX-33HP 8 stron. 10 meter amateur mobile transceiver
Drukuj stronę
4.
RF GAIN CONTROL (outer dual concentric). Use to reduce the gain of the
receive under strong signal conditions.
5.
MODE (PA/FM/AM) SWITCH. This switch is used to select PA, FM, AM
mode of operation. When you set to PA position, the transceiver acts as a
public address amplifier. Before operating PA, you must first connect an
external PA speaker (8 ohm, 4-watt) to the PA Speaker jack on the unit rear
panel.
6.
BAND SELECTOR. This switch is used to select the band.
7.
ECHO. This control is used to echo effect.
8.
TIME. This control is used to intervals of echo sound.
9.
CHANNEL SELECTOR. This switch selects any one of the forty channels
desired. The selected channel number on the LED readout directly above the
Channel Selector knob.
10. METER. This meter indicates received signal strength, transmitter RF output
power.
11. RF POWER. This switch is used to select transmitting power. In the HI
position, the transceiver operates at 10 watts RF output power. In the MED
position, the transceiver operates 5 watts RF output power. In the LO position,
the transceiver operates in 2 watts RF output power.
12. OFF/ANL/NB. When the switch is placed in the ANL+NB position, the RF
Noise Blanker is also activated. The RF Noise Blanker is very effective for
repetitive impulse noise such as ignition interference.
13. BAND SWITCH-HI/LOW. This switch is used to select High band and or
Low band Frequency Range.
14. OFF-ECHO SWITCH. This switch when set to ECHO position, will add an
echo effect to your voice.
15. RECIEVER/TRANSMIT
INDICATOR.
indicator is located next to the channel indicator. When in receive, the LED
will be green. When in transmit the LED will be red.
16. CHANNEL INDICATOR. Numbered LED indicates the selected channel
you wish to operate on.
The
receiver/transmit
-9-
REAR PANEL
17. POWER. Accepts 13.8V DC power cable with built-in fuse (10 amp.) to be
connected.
18. EXT SP. Accepts 4 to 8 ohms, 5-watt external speaker to be connected. When
external speaker is connected to this jack, the built-in speaker is automatically
disconnected.
19. PA. SP. Used to connect a PA speaker (8 ohm 4W) for PA operation. Before
operating PA you must first connect a PA speaker to this jack.
20. ANTENNA. Accepts 50 ohm coaxial cable with a type PL-259 connected.
21. F.C. This socket is for the optional FREQUENCY COUNTER model FC-347,
The FC347 will indicate the transmit and receive frequency.
LED
19
18
PA. SP.
EXT. SP
ANT.
F.C.
-POWER+
MADE IN MALAYSIA
20
17
21
-10-