Galaxy DX-66V Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Transceiver Galaxy DX-66V. Galaxy DX-66V 10 stron. Full channel am/fm mobile transceiver built in frequency counter with roger beep

Drukuj stronę

5. E-TONE. This control is used to echo effect and intervals of echo

sound.

6. DIMMER (inner dual concentric). Turns on/off the frequency display,

channel number and the meter lamp. Switch on at minimum brightness,

rotate further to get brighter illumination.

7. RF POWER CONTROL. Adjust this control to acquire RF power level

you desired in AM or FM transmission.

8. CHANNEL SELECTOR. This switch selects any one of the channels

desired. The selected channel appears on the LED readout directly above

the Channel Selector knob.

9. BAND SELECTOR. This switch selects A, B, C, D in Hi or Lo band of

operation.

10. BAND SWITCH-HI/LOW. This switch is used to select High band and

or Low band Frequency Range.

11. CLARIFIER. Allows variation of the receiver operating frequencies

above and below the cassigned frequency. It may be used to optimize

AM/FM signals as described in the Operating Procedure paragraphs,

operates both TX/RX.

12. R.B./OFF. When this switch is placed in the ROGER BEEP position,

you radio automatically transmits the audio sign at the and of your

transmission. The listener can note easily your transmission is over

through the sign.

13. MODE (PA/AM/FM) SWITCH. This switch is used to select PA, FM,

AM mode of operation. The AM or FM mode is normally, but when you

set to PA position, the transceiver acts as a public address amplifier.

Before operating PA, you must first connect an external PA speaker (8

ohm, more than 2W) to the PA Speaker jack on the unit rear panel.

14. FREQUENCY COUNTER. This frequency counter indicates the

selected frequency you wish to operate on.

15. OFF/NB/NB+. When the switch is placed in the NB position, the RF

noise blanker also is activated. The RF noise blanker is very effective for

repetitive impulse noise such as ignition interference. If you wish to turn

off the frequency display only set switch to NB+ position.

- 9 -

16. +10KHz FREQUENCY SHIFT SWITCH. When switch is pressed the

frequency is shifted 10KHz up. On following channels. A channel can

be used by setting this switch to +10KHz position.

Normal

17. METER. This meter indicates received signal strength, transmitter RF

output power and SWR level.

18. CHANNEL INDICATOR. Numbered LED indicates the selected

channel you wish to operate on.

+10KHz

11A

15A

19A

- 10 -