909 PS26W Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła 909 PS26W. 909 PS26W 20 stron. 26cc pole trimming saw
Drukuj stronędust. Wear safety glasses to protect your eyes whilst
cleaning.
If the body of the saw needs cleaning, wipe it with a soft
•
damp cloth. A mild detergent can be used but nothing like
alcohol, petrol or other cleaning agent.
•
Never use caustic agents to clean plastic parts.
Turn the bar periodically to use both the sides so that
•
it wears evenly.
It is essential that motor cooling vents are kept free from
•
a build-up of sawdust and this decreases the engines
cooling capacity and causes overheating damage to the
motor as well as other important equipment, oil pump etc.
It is recommended that this is carried out after every use.
Clean the guide and oil holes periodically.
•
Deburr the race sides periodically with a flat file. Time
•
may cause any "Burrs" to detach and damage the bar.
The bar needs to be evened with a flat file if one of the
•
races is higher than another and then smoothed with a
file and fine sandpaper. If races are considerably worn,
check that the height is always greater than the chains
transmission links so that the latter do not touch the
bottom. Replace the bar if this should occur.
•
Make sure that the oil port is not clogged. Grease the
nose sprocket at the tip of the guide bar each time the
chain is filed.
Grease the head gearbox of the pole saw every 50 hours
•
of operation.
The pole saw should be periodically serviced to check the
correct operation of the chain, chain drive and engine.
CAUTIoN.
Water must never come into contact with
the pole saw.
First time user
If you are not familiar with pole saws and the felling of trees,
it is recommended that you obtain informed instructions in
addition to reading this manual fully. We also recommend as
a minimum that you practice cutting logs on a saw-horse or
log cradle.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
Storage
Clean the pole saw with a dry cloth, do not use
•
aggressive cleaning fluids.
Replace the pole saw blade cover and store in a dry
•
place. Do not store in hot, dry boiler rooms or other damp
places.
Drain all fuel from the fuel tank
•
If you do not intend to use the pole saw for some time, e.g.
over the winter, the saw oil must be drained from the oil
tank and the oil ducts, because it will gum. Pour remaining
oil out of the oil tank and store it in a dark, cool place. Pour
a spoonful of mineral oil into the oil tank. Spray penetrating
lubricant on the chain and let the saw run for a few
moments to spread the mineral oil through the oil pump and
the oil ducts. When using the pole saw again liberally apply
chainsaw oil.
Repairs
Repairs beyond those described above, should only be
undertaken by trained personal. Should a malfunction occur
do not use the unit any further and do not attempt to repair
it yourself. Contact 909 Customer Support or have the unit
repaired by a professional.
16