Hifonics Titan Series TXi 1700 Instrukcja obsługi - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz samochodowy Hifonics Titan Series TXi 1700. Hifonics Titan Series TXi 1700 20 stron.
Drukuj stronę
Speaker & RCA Connections
FULL-MODE / Connection of a Loudspeakersystem
• Connect the "LINE IN" of the amplifier to the head unit´s line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT - and +) of the amplifier.
• The minimum final speaker impedance must not be lower than 1 Ohms in total. Too low speaker loads result in too high heat dissipation and may
cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal.
• Caution: The loudspeakers don´t get a stereo-signal. If you want to get a stereo-signal you have to use a second amplifier in
Master/Slave-Mode.
• If your head unit has an subwoofer line output with an integrated crossover you are able to use one or two subwoofers in Full-Mode.
By using a additional subwoofer,
connect it to the non-occupied
terminals, ensure that the total
impedance load is not lower
than 1 Ohm.
In this mode PHASE - Control, LOW PASS - Control, SUB SONIC - Control and BASS REMOTE are out of function.
MODE - Switch
• Set the switch in this operation mode to "FULL" - position.
FREQ RANGE - Control
• Allows you to adjust the frequency at which the bass boost should work. It is continously variable between 20Hz up to 80Hz.
Q-Control
• Allows you to adjust the filter performance Q of the crossover. So you can change the playback quality in the range of the cut-off
frequency."WIDE" Q - 0.3, "NARROW" Q - 1.0. Regular setting is on 12 o`clock - position Q - 0.5/Linkwitz-Reilly and
3 o`clock - position Q - 0.7 /Butterworth.
SUB BOOST - Control
• Allows you to adjust the bass boost from 0dB up to 18dB.
LEVEL
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
TXi 1700
Do not connect speaker (-) to the ground or vehicle's chassis.
Mono Speakers 2 - 8 Ohm
Caution!
In this example the Bass-Remote-Control can not be used!
Connect RCA outputs of the head unit with
LINE IN of the amplifier.
15