dbx iEQ-31 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający dbx iEQ-31. dbx iEQ-31 20 stron. Graphic eq
Również dla dbx iEQ-31: Podręcznik użytkownika (16 strony), Specyfikacje (2 strony), Szybki przegląd (4 strony)

Drukuj stronę

Installation Recommendations

FOR RACK MOUNT USE ONLY - Install the iEQ in your rack with the provided rack screws�

When installed in a rack, the unit should be positioned with enough room (at least one 1U above the

unit and 1U below the unit) to allow proper ventilation� The iEQ should not be mounted above or

below anything that generates excessive heat� Ambient temperatures should not exceed 113

when equipment is in use� Although the unit is shielded against radio frequency and electromagnetic

interference, extremely high fields of RF and EMI should be avoided where possible�

Basic Connection of the iEQ

The iEQ Series Equalizers have balanced inputs and outputs that can be used with any balanced or

unbalanced line-level device�

To connect the equalizer to your sound system refer to the following steps:

Installation

• Turn off all equipment before making connections�

• Make audio connections via XLR, 1/4" TRS jacks, or Euroblock connectors according to

application needs� All three types of connectors for the inputs and outputs can be used for

balanced or unbalanced connections� The use of more than one connector at a time for the

inputs could unbalance balanced lines, cause phase cancellation, short a conductor to ground,

or cause damage to other equipment connected to the equalizer� More than one output may be

used simultaneously as long as the combined parallel load is greater than 600Ω.

• Select the operating range with the Boost/Cut range selection switch�

NOTE: Whenever amplifiers are powered on, be sure to reduce audio levels at the power

amplifiers when changing the setting of this switch as it may generate an audible transient�

• Apply power to the equalizer� Connect the AC power cord to the AC power receptacle on

the back of the equalizer� Route the AC power cord to a convenient power outlet away from

audio lines� The unit may be turned on and off from the rear panel power switch or a master

equipment power switch� Since the iEQ Series Equalizers consume a relatively small amount

of power, the units may be left on continuously�

iEQ User Manual

iEQ

F (45