dbx mc6 Mini-Comp Podręcznik - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt nagrywający dbx mc6 Mini-Comp. dbx mc6 Mini-Comp 16 stron.

When the tip is shorted to the sleeve, compression is active; when the tip is not shorted to the

sleeve, the unit is bypassed. The front panel BYPASS LED is activated when the footswitch

controller is operating the bypass mode of the MC6. In order for the footswitch to operate, the

front panel BYPASS SWITCH must be deactivated, or in the "out" position. Similarly, the rear

panel FOOTSWITCH must be in the shorted position for the front panel BYPASS SWITCH to

work.

MC6

ONNECTING

The MC6 can be used with any line-level or intrument level device (see specifications on page

11). Some common examples include mixing consoles, electronic musical instruments, patch

bays, and signal processors. For all connections, refer to the following steps:

Turn Off all equipment before making any connections.

Make connections via 1/4" phone jacks according to your requirements.

Typical patch points include: a mixer's channel or subgroup inserts when using the MC6 on

individual instruments or tracks; the mixer's main outputs when mixing; an instrument

preamp's effects loop when using the MC6 for guitar or bass; main outs of a submixer (i.e.,

keyboard mixer) as the signal is sent to main mixer; between a DAT's output and an analog

cassette input.When using a chain of processors, the MC6 may be placed either before or after

effects or dynamics processors. It can also be placed first in a chain of guitar pedal effects,

where a guitar may be plugged directly into the MC6 mono input. We recommend you use

common sense and experiment with different setups to see which one provides the best

results for your needs.

Connect the DC power cord (shipped with the unit) to the MC6's rear panel POWER

connector and an appropriate AC power source to turn the unit ON.

MC6

Outputs

insert

returns

OUR

YSTEM

Use the MC6 to

MC6

Inputs

compress those

pesky individual

tracks by

inserting it in

the insert path

insert

of your mixer

sends

for a single

channel or for a

(stereo) linked

pair of signals.