Adeneo Embedded i.MX53 Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Płyta główna Adeneo Embedded i.MX53. Adeneo Embedded i.MX53 20 stron. Quick start board bsp for android gingerbread v4.2

Drukuj stronę

● If you are using an external monitor (VGA, HDMI), make sure to configure the display

when you boot or the board will appear to be stuck at the touchscreen calibration screen.

● Flashing standard binaries built using the above build scripts:

$ ./flash_android.sh /dev/sdX

Notes:

● When using the provided build scripts all binaries are copied automatically to the "out"

directory. This is the location that flash_android.sh uses for binaries.

● This script will erase the existing U-Boot environment and restore the default boot

configuration. Please edit the script and remove the corresponding section if you do not

want this feature (the section is highlight in the script).

● You need to build Android once in order to flash these images.

● Flashing prebuilt binaries (prebuilt binaries are provided with this release - they can be

found in the prebuilt directory):

$ ./flash_prebuilt_android.sh /dev/sdX

● Flashing prebuilt + Inflexion UI demo binaries built using the above build scripts:

$ ./flash_prebuilt_android.sh /dev/sdX --inflexion

These binaries add the Inflexion UI demo, which can replace the Android standard

Launcher (hence the prompt when the board is booted or when the HOME button is

used).

Note: The Inflexion UI demo will not work for all resolutions.

Booting the board

● The Quick Start Board will boot from the Micro SD slot of your board. Insert the SD Card

in that slot and turn on the board (the LEDs should turn blue and green).

● If this is the first time you boot Android on your SD Card, the process will take more time

than usual and prepare the user data files. The calibration will also appear the first time

before launching Android.

● If you need to interact with the console (bootloader, kernel or Android), you will need to

connect a serial cable to the DB9 port of your Quick Start Board.

Serial parameters: 115200bps, 8n1, no flow control.

● To access the bootloader, hit a key in the serial console when you see the following

message: "Hit any key to stop autoboot".

01/29/2012

Adeneo i.MX53 QSB BSP for Android Gingerbread 4.2

Page