Galaxy LEC Instrukcja instalacji i obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Sprzęt elektryczny Galaxy LEC. Galaxy LEC 4 stron. Electronic ballast

NOTE - Until the lamp has achieved at least 10 hours of operation, the lamp should

never be turned off sooner than 2 minutes. This includes installation test. In cases

where this happens—you need to wait 1 hour before switching the lamp on again.

LAMP REPLACEMENT - Be sure to disconnect the power source before

changing lamps. Always use a 315 watt Ceramic Metal Halide lamp

(ANSI C182/0 or C182).

MOUNTING LOCATION - DO NOT install ballasts in areas of high heat, such

as an attic or a closed closet. DO NOT mount the ballast to the reflector or blow

exhaust air over them. DO NOT stack ballasts on top of each other. DO NOT allow

contact with water. Mount units at least six inches apart. If a unit has any leaking

resin, please relocate to a cooler area or place a fan near the ballasts.

TIMER BOX - If you are connecting a 240V ballast to a timer box, please make

sure that it cuts off both legs when timer is switched off. If you continue to supply

120V to your ballast when the timer is switched off, it may damage your ballast.

ERROR CODES - If the ballast encounters any abnormal conditions the built in

self-diagnostic feature will display easily identifiable error codes. Error codes can

be identified by the number of flashes made by the green LED marked "turbo" .

1 Flash = Ballast Protection: This code means that the ballast has gone into

a locked mode to protect itself. This may be followed by another code

to help troubleshoot the cause.

2 Flash = Bad Lamp/Short Circuit: This code means that the ballast has a

bad connection somewhere between the ballast and lamp. Reasons

can include a bad lamp, loose lamp, loose lamp cord, a short in the

cord or reflector, or a short in the ballast receptacle.

3 Flash = Low Voltage: This code means the power coming from the outlet

to your ballast is not sufficient to power the unit.

4 Flash = Over Temperature: This code means the ballast has shut itself off

due to overheating (>140° F).

5 Flash = Over Voltage: This code means the power from the outlet to your

ballast has exceeded the maximum allowed voltage.

See back page for important troubleshooting, FCC and warranty information