Galaxy Audio ECD Any Spot Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System mikrofonowy Galaxy Audio ECD Any Spot. Galaxy Audio ECD Any Spot 9 stron. Wireless microphone system dual channel system

Galaxy Audio ECD Any Spot Podręcznik użytkownika
Trips for improving System Performance
Trips for improving System Performance
Maintain a line of sight between transmitter and antenna.
Avoid placing the receiver near metal surfaces or any digital equipment (CD players, computes, etc)
Keep the receiver away from the wall and over 3ft. from the ground
Cellular telephones, two-way radios and other RF sources can interfere with the transmitting
frequencies. Maintain the greatest distance possible from the interfering equipment to minimize
interference.
Trouble Shooting
Issue
No sound or faint
sound
Distortion or unwanted
noise bursts
Distortion level
increases gradually
Sound level different
from cabled guitar or
microphone, or when
using different guitars
5
Indicator Status
Not Transmitting
Not Receiving
Receiver RF indicator glows
Receiver RF indicator off,
transmitter on
The battery power indicator
light flashes or turns RED
Receiver display indicates
RF/AF
Transmitter power indicator
light flashing
Solution
Turn on transmitter
Make sure the +/- indicator on the batteries
match the transmitter terminals
Make sure the AC adapter is securely
plugged into electrical outlet and into
DC input connector on rear panel of receiver.
Turn up the receiver's Audio Output level
Control up adjust the Gain switch on the
transmitter Check the power connection of
the receiver and amplifier or mixer
Move the receiver away from metal objects
Check whether there is an obstruction
between receiver and transmitter
Move the transmitter near the receiver
Re-Sync receiver and transmitter
to the same frequency
Change the batteries the in transmitter
Remove nearby sources of RF inter-
ference (CD players, computers, digital
effects, in-ear monitor systems, etc.)
Replace transmitter batteries
Adjust transmitter again and receiver
volume as necessary