909 ES99 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kosiarka 909 ES99. 909 ES99 20 stron. 99cc 400mm (16") electric start 4 stroke petrol lawn mower

Drukuj stronę

Fuelling

IMPORTANT.

Fuel goes off after about 3-4 months. If you find

your mower does not start, first change the fuel in the tank

with newly purchased fuel. Fuel should also be drained from

the carburettor bowl by removing the small drain plug on the

under SIDE of the bowl. (21). Do Not remove the centre bolt.

After draining the fuel from the bowl, replace the plug ensuring

the sealing washer is in place under the head of the plug.

WARNING.

•

Do not refill fuel tank (9) while engine is running or is hot.

•

Be careful not to admit dust, dirt, water or other foreign

objects into the fuel.

•

Wipe off spilt fuel thoroughly before starting engine.

•

Ensure you DO NOT fuel the lawn mower in close

proximity to any open flames, lit cigarettes, or hot objects.

Note:

Do not use ethanol fuel (E10). Use fresh 91 Octane

unleaded petrol.

1. Unscrew the fuel tank cap

(10) and pour unleaded petrol

into the tank with the aid of a

funnel.

2. Fill the tank to approximately

2.5 cm below the lowest

portion of the neck to allow for

fuel expansion. Replace the

cap firmly. Be careful not to

over fill.

3. Be careful not to spill any

petrol, if this happens, wipe

the spill with a clean rag.

4. Start the engine at least three

metres away from the

area where the fuel tank has

been filled in order to avoid

the risk of fire.

WARNING.

Never attempt to refuel the engine while it is

running or still warm, allow it to cool before fuelling.

Starting the engine

Note.

Before starting the mower check the oil and fuel

levels. Warranty will be void if the engine becomes faulty

due to insufficient oil and fuel levels.

Ensure the mower is set to the highest height setting so the

blades are not resting deep into the grass.

To start the mower manually (Recoil Starter)

1. Turn the Key switch to the ON

position as shown in Fig A.

2. Depress the priming bulb

(20) fully 2-3 times. DO NOT

PRESS THE PRIMER BULB

MORE THAN 3 TIMES. You

will flood the engine and it will

be hard to start.

3. Pull the recoil starter (12) lightly

until you feel resistance then

pull quickly until the engine

starts. Do not pull the cord with

a jerk or release it until fully

rewound.

4. To stop the engine turn the key

to the off position.

To start the the mower with the electric

start system

Note:

Key start function will not work if the battery is not

connected.

1. Check the battery plug

connection. The plug of the

battery must be connected to

the plug of the mower.

The plugs are not connected

during transport and will need

to be inserted together before

attempting to use the electric

start.