909 KSBL26CCG Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Dmuchawa 909 KSBL26CCG. 909 KSBL26CCG 15 stron. 26cc full crank key start petrol blower

Drukuj stronę

Assembly

IMPORTANT.

Blower tube installation affects both

blower balance and performance. Both tube and nozzle

must be screwed together.

WARNING.

Danger from rotating impeller!

Stop the engine before installing or removing the blower

tubes. Never perform any maintenance or assembly

procedures on this machine while the engine is running.

1. Place the blower upright on the ground or on a sturdy

work surface.

2. Push the nozzle tube (5) over the straight tube (4), lining

up the locking pins.

3. Rotate the nozzle tube clockwise locking it into place.

4. Lock the tubes together using the 2 screws provided.

5. Align and then push the

assembled blower tube over

the discharge port and rotate

until locks in place and the

screw hole can be seen.

6. Screw the tubes together

using the screws provided.

Mixing the fuel

ENGINE FUEL: MIX AT 40:1

WARNING. When mixing fuel it is recommended to wear

eye protection, and to mix fuel in a well ventilated location.

Note. This is 25mls of 2 stroke oil with 1 litre of unleaded petrol

OR 125mls of 2 stroke oil with 5 litres of unleaded petrol.

IMPORTANT.

Use good quality air cooled 2-stroke

engine oil.

This product is powered by a 2-stroke engine and requires

the pre-mixing of fuel with 2-stroke oil.

1. Use fresh unleaded petrol and a good grade of 2 stroke

oil for air cooled 2 stroke engines.

2. Mix the petrol and oil in an approved container.

Never mix fuel directly in the blower fuel tank.

A fuel mixing container is provided with this blower.

Directions.

Place the plastic mixing bottle on a level

surface. Fill with unleaded fuel in the container to the top

500 marker in the column GAS.

Then with 2 stroke oil, fill to the top line maker in the 40:1

column. Replace the cap on the mixing bottle and shake the

container to mix the fuel and oil.

The fuel is now correctly mixed at 40:1 and is ready to be

poured into the petrol tank of the blower.

NOTE,

this container provided is NOT a fuel storage container.

WARNING. Never use any type of pre-mixed fuel/oil direct

from fuel stations. This may include special blends intended

for use in mopeds, motorcycles, etc.

3. Mix the fuel thoroughly and also each time before fuelling.

4. Always pre-mix in small quantities. Never mix quantities

larger than what will be used in a 30 day period.

Note.

Do not store petrol in plastic containers.

Keep fuel out of the reach of children.

40:1