Galaxy Audio JIB/PA50 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Galaxy Audio JIB/PA50. Galaxy Audio JIB/PA50 8 stron. Jacks in the box compact power amplifier 25w x 2

Drukuj stronę
Step 2
Use standard RCA connectors and/or 1/8"
1.
(3.5mm) mini-cables to connect the input
devices (e.g., the projector, other audio sources)
to the power amp.
Match the wiring polarity. For example, red
for positive, black or white for negative.
Make sure no wire strand bridges (shorts)
the adjacent terminals.
2.
Insert all four wires on each speaker into the
blue 4-pin captive screw plug supplied with the
power amp.
Use a #1 Phillips screwdriver to tighten the
locking screws.
Step 3
When wiring the 10V, Vol/Mute and GND
outputs, strip off the insulation from the
external volume control wire by 3/16". Make
sure the wire ends do not touch. Keep
exposed wire ends short after stripping. If the
wires touch, they may short the amp.
1.
Follow the 10k Pot Volume Wiring Diagram
to connect the external volume control to the
amp (Figure 4).
Figure 4
10k Pot Volume
Wiring Diagram
Pot Volume
10K Ohm
Installing the Compact Power Amplifier
Installing the Compact Power Amplifier
VOLUME
10V (Pin 1)
Vol/Mute (Pin 2)
GND (Pin 3)
3.
Insert the captive screw plug into the
receptacle on the amp's rear panel
(see drawing).
4.
Attach the power amp plug to the
amplifier.
Do you need to wire the 10k pot
volume? If Yes, proceed to Step 3
below
Amp Receptacle for the
Blue 4-Pin Captive
Screw Plug
Insert all three pins from the external
2.
volume control into the green 3-pin
captive screw plug supplied with the
amp (see drawing).
Use a #1 flat blade screwdriver to
tighten the locking screws.
3.
Insert the captive screw plug into the
receptacle on the amp's rear panel
(Figure 5).
Figure 5
4
Amp Receptacle for the
Green 3-Pin Captive
Screw Plug