DC Athletics CANNIBAL I Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Rower treningowy DC Athletics CANNIBAL I. DC Athletics CANNIBAL I 6 stron. Speed bike console

Put 2 pieces new battery of 1.5V AAA inside the computer correctly, and ride the bike several circles

within 2 minutes (for the sensor already installed battery). Make the wireless sensor receive the signal

from the magnet moving. Or replace the battery of the sensor within 2 minutes, and then the

computer will finish the code matching with the sensor automatically. Once finished the code

matching, the computer will display the measured data automatically

Remarks:

① Make sure the sensor will receive the signal from the magnet

② After the battery replacement of the computer, if not receiving the sensor 's signal or the sensor

did not replace battery within 2 minutes, the computer will save the coded data of last time

automatically

③ Only one set of products can operate the code matching at the same time

④ The distance between the computer and the sensor should be no more than 2M

⑤ After the code match operation ，if the computer still can not display the measured data, please

check the sensor 's battery is installed properly or not ，or the whether the battery voltage is over

2.6V, or the place between magnet and sensor is correctly or not ，or whether there's several sets

of product s are operating the code matching. After the above confirmation, operate the code

matching again

2.RESET

In any displays, hold MODE button for 2 second s to reset all the data

SET THE TARGET PARAMETERS

When stop exercise (icon 0 not display) ，press MODE to choose the window to be set or reset，the

corresponding window displays SET，meanwhile ，the window's digit flash ，press RESET to clear the

value，and press SET to set the flashing window's value. Hold the button to quick increase

Set the value as: TIME→DIST→CAL.

CHECK THE EXERCISE DATA

① In non- set mode，press SET or during exercise ，icon 0 displays ，press MODE to separately

check the SPEED / AVG. SPEED /MAX SPEED，CALORlES/ RPM ，PULSE/AVG. PULSE/ MAX PULSE .

② When icon 0 displays，it means the computer is scanning the display. lt will scan the display the

value in corresponding window every 6 seconds

5. PULSE RECOVERY

Wear the transmitter belt properly, or hold the hand pulse place ，the computer will display your

current heart rate

When the pulse window has the display, stop exercise ，press RECOVERY to enter the function of

pulse recovery. The display will show 1 minute countdown as well as your pulse rate, test your pulse

until it counts down to zero. Then it will pop up your pulse recovery level from F1 to F6，that is, from

the fastest recovery to the slowest. The fastest recovery F 1 shows the best, F6 mean s the slowest.

Press RECOVERY again to exit the pulse recovery function.