DC Power Solutions B-COOL9000RM-24V Podręcznik - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik dla Akcesoria samochodowe DC Power Solutions B-COOL9000RM-24V. DC Power Solutions B-COOL9000RM-24V 16 stron.
Również dla DC Power Solutions B-COOL9000RM-24V: Instrukcja obsługi (12 strony)
Drukuj stronę
ERROR Codes displayed on the controller
If, while the air conditioner is running, any of the following codes appear on the
controller screen, please take the following steps as the code may indicate a serious
problem
1: STOP THE AIR CONDITIONER & POWER OFF.
2: AFTER 10 MINUTES POWER ON & START A/C
3: IF THE CODE PERSISTS - STOP A/C & POWER OFF
4: CONTACT REPAIR CENTER.
E01 - Voltage is too low -
E02 - Evaporator blower is not
Also check blower and replace if defective.
H22 / H23 -
Check evaporator inlet sensor by powering down the air conditioner and restart the air
conditioner. If the code reappears it means that the sensor is defective or has become dislodged from the
evaporator coil.
E04 -
Temperature sensor of the plenum
E05 - Compressor over temperature indicator.
down so as not to damage the unit. This may happen if the ambient temperature is very high. Once the
compressor cools the unit will restart again.
E06 / E07 - Condenser fan is not
defective and needs to be replaced
E09 -
Condenser fan control board is defective and should be replaced.
E10 -
Condenser fan failure - Replace the condensing fan motor
E11 - The condenser fan is not operating.
NOTE: If the number flashing on the indicator is not shown in this table, please replace the
compressor control panel
Charge the battery or Start the Engine
operating. Check wiring and voltage of the supply wiring and repair.
operating. Check the wiring and voltage. Also check fan as it may be
Check the wiring for damage.
1
11
This will power off the unit until to compressor cools