dynarex Bari+Max 10446 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wyposażenie wnętrz dynarex Bari+Max 10446. dynarex Bari+Max 10446 8 stron. Bariatric airfloat air mattress with pump

Drukuj stronę

Bari+Max

Support Where You Need It

STORAGE

1. Switch off power from main and unplug,

separate the pump from the mattress

and place the mattress ﬂat.

2. Fold the mattress in two from mattress

foot to head.

3. Allow time for air to escape from

mattress to reduce storage space.

4. Close the protective cap cover on the

quick connector.

SPARE PARTS/ACCESSORIES

For spare parts and accessories please

contact Dynarex or an authorized dealer.

GENERAL CONDITIONS OF DISPOSAL

Dispose of the device in the appropriate

disposal areas for recycling.

At the end of its life, the product must not

be disposed of along with other domestic

waste. Dispose of this equipment by

bringing it to a designated recycling point

for electric and electronic equipment or

others that provide this service.

TROUBLESHOOTING

If your questions can't be answered with

below information, please contact your

local agent directly. They might require a

technician to take care of the problem.

No lights on unit

Low pressure alert

Patient's body is

sagging in the

middle/bottoming out

Control lock up

or "freeze"

Check control unit is connected to the main power supply and that

the unit is switched on.

Check quick blow fuse on the control unit or mains plug fuse.

Check main power to the control unit and that the plug is switched.

Check mattress air supply connector is connected to the pump

unit correctly.

Check CPR connector is connected properly.

Under the mattress cover check all "T" & "L" connectors are

connected to the air tubes.

Check the connector tubes for kinks, crimps or damage.

Increase the value of the comfort setting. Wait a couple of minutes

so pressure can stabilize before making another change.

Turn the control unit off and unplug the pump. Wait a few minutes

and plug the control unit back in. Turn on the control unit.

MAINTENANCE

In case of repair, use only original spare

parts and accessories.

CLEANING AND DISINFECTION

WARNING!

Unplug the pump before starting

the cleaning procedure.

1. Clean the mattress with mild soap.

2. Do not immerse or soak pump unit.

3. After cleaning, dry the mattress without

direct sunlight exposure.

4. Check that the connection tubes are not

obstructed by dust or other object. Use a

soft swab to clean the tubes if necessary.

NOTE:

Never use acids, alkalis or solvents

such as acetone to clean the mattress.