iHealth BP7 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi iHealth BP7. iHealth BP7 16 stron. Wrist
Również dla iHealth BP7: Skrócona instrukcja obsługi (4 strony), Instrukcja obsługi (16 strony)

Drukuj stronę

MEASUREMENT PROCEDURES

Blood pressure can be affected by the position of the cuff and your physiologic

condition. It is very important that you keep your wrist at heart level.

1. Be seated comfortably with your feet flat on the floor without

crossing your legs. Stay still during measurement. Do not move your

wrist, body, or the monitor.

2. Place your hand palm-side up in front of you and wrap the cuff

around a bare wrist 1-2cm above the wrist joint. If the monitor is

correctly placed, iHealth logo will be facing upright.

3. The middle of the cuff should be at the level of the right atrium of

your heart.

4. It is advised to place the monitor's travel case under your arm for

support and to keep your arm at optimal height for measurement.

5. Adjust the height of your wrist, the App will detect your wrist

position and the measurement will start ONLY when the correct

position is detected. Follow the on-screen instructions to begin

measurement.

Remember to:

1. Make sure that the appropriate cuff size is used; refer to the cuff

circumference range in "SPECIFICATIONS".

2. Measure on the same wrist each time.

3. Stay still and calm for one to one and half minutes before taking a blood pressure

measurement. Prolonged over-inflation of the bladder may cause ecchymoma of your

arm.

4. Keep the cuff clean. Cleaning the cuff after every 200 times of usage is

recommended. If the cuff becomes dirty, clean it with a moistened cloth. Do not rinse

the monitor or cuff with running water.

Press the "START/STOP" button to stop measurement. Press the "START/STOP"

button for 2 seconds to turn off the monitor manually.

Auto Connect Option

Auto connect option allows the monitor to find the last used iOS device and

reestablish the connection with your iOS device automatically. Auto connect

option can be enabled in the App. (Device Setting->Auto Connect->On).

Taking Measurements with Multiple iOS Devices

Turn off the Bluetooth on the last used iOS device if the Auto Connect option is