iHeat Roof Mount Solar Hot Water Systems Instrukcja instalacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Podgrzewacz wody iHeat Roof Mount Solar Hot Water Systems. iHeat Roof Mount Solar Hot Water Systems 15 stron.
Drukuj stronęSECTION 5
PROBLEM
Water not as hot
as previous hot
water system
No Hot Water
Overflow pipe is
dripping
Water pressure
is slightly lower
than previous hot
water system
After Sales Service Guaranteed
iHeat pride ourselves in responsive after sales service, If the system is still not operating correctly.
Under no circumstances should repairs be attempted by unqualified persons.
Thank you for joining iHeat in our mission to leading the way to a sustainable energy future.
Supplier Name: __________________________________________________ Installation Date: _______________
Supplier Address:________________________________________________
___________________________________________________________________
System Model / Type: ___________________________________________
Installation Manual - Roof Mount Solar Hot Water - August 2017
Trouble Shooting
SOURCE
Tempering Valve installed
Electric or gas booster is not
turned on or not configured
correctly
Pressure Temperature
Relief Valve (PTR) /
Expansion Control Valve
(ECV) where applicable.
Pressure Reduction Valve
(PRV)
SOLUTION
A tempering valve must be installed on every
solar hot water system. Tempering valves will
mix water down to 50°C.
Electric booster should be set to at least 60°C.
Ensure circuit breaker is switched on. Ensure
power is switched on to gas booster. Ensure
mains gas supply hasn't been isolated.
An 850kPa and 99°C PTR valve is used on the
iHeat water tank, which is located on the side
of the water tank and is essential for its safe
operation. The PTR valve is designed to allow
3-5% of total tank volume to discharge during
heating to allow for hot water expansion.
A pressure reduction valve has been installed
to limit the inlet pressure to your new iHeat
Water Heater. This device regulates the
incoming pressure & increases life of the
cylinder. This device will also protect your
cylinder if the mains pressure is increased by
the local water authority.
Supplier Phone: _________________
1300 829 118
i-heat.com.au