Gale 4070 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Subwoofer Gale 4070. Gale 4070 12 stron. 40 series

Drukuj stronę

Attaching feet to your subwoofer

Your 4070 subwoofer comes with feet and spikes which should be

fitted as outlined below.

The spikes attach to the bottom of the feet (as shown below left).

There are eight pilot holes on the bottom of the speakers. The feet are

located and secured here with the wood screws supplied (below right).

Level as required.

fig. a

Scale

Colour Definition

NTS

Pantone BLACK 100%

(Orig Only)

Sheet

Material

125gsm

Drawn

Checked By

VLB

Getting Started

Connecting via Line Input

If your amplification system has a dedicated subwoofer line output

then you should connect your 4070 via the Line Input on the rear panel

using a good quality phono lead.

system has a mono subwoofer line out then use the Left/Mono socket

on your 4070.

Connecting via High Level Connections

Do not compromise the performance of your system by using inferior

quality cables! Gale recommends that high quality cables of 16 gauge

or higher be used. Your professional dealer will give you good advice.

Observing polarity is of the utmost importance while connecting your

loudspeakers. Ensure that the red (+) terminals on your amplification

system are connected to the red (+) on the subwoofer, and black (-) on

your amplification system to black (-) on your subwoofer.

Important Note:

before making any loudspeaker or component connections. This will

avoid the risk of electric shock or damage to your equipment.

Running In

fig. b

Your new unit will require a total of approximately 10 hours of normal

use to allow the components to settle into their working routine and

reach their optimum performance.

Drawing Title

Gale 4070 manual

Signed off

Drawing No

VBW

AP18039/1.

Note that if your amplification

Always unplug all A.C. powered components

Revisions & Date

1: 31/05/05