DCbright DL1-AC-400W-64 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt oświetleniowy DCbright DL1-AC-400W-64. DCbright DL1-AC-400W-64 19 stron.

Drukuj stronę

Operating Instruction

no. :

Dark Licht Operating Instruction

date:

06/12/23

page:

12/19

Installation - installation instructions

To determine the correct angle of adjustment of the luminaire, follow the instructions of the lighting plan and/or the supplier. Before

installation, always check that the installation site is completely level.

Only install the fixtures at mounting locations that have been pre-approved or inspected by a certified company.

It is recommended to start installation as close to the power point as possible.

The weight of the connecting cable must not load the luminaire.

To protect the light module and to avoid the risk of injury, gloves should be worn during assembly and installation.

The drivers, driver box or driver tray and other components must be properly grounded.

Check that the degree angle is set correctly before tightening the bolts

Check that all bolts and cable glands are properly tightened.

After installation, the point furthest from the grounding installation should be professionally checked in accordance with local law.

Make sure that the power supply is switched off before connecting the LED fixture.

Installation of the LED fixtures may only be carried out by authorized persons with sufficient knowledge.

Do not stare at the operating light source.

Attention: To check the authenticity of testing/inspection report & certificate, please contact us at telephone: +86 139 1666 5083, or email: [email protected]

WARNING - DANGER

For example by means of an earth claw or a pre-installed earth cable.

see tables: "Cable gland - Advised tightening in mm" and "Bolt - tightening information" below

dcbright.com

[email protected]