DCD 61400-000 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenia przemysłowe DCD 61400-000. DCD 61400-000 14 stron. Lineman lasher

8. Installing the overlash assembly front rollers:

DCD offers the 61438-000 Overlash assembly for installing larger cables or

overlashing smaller cables to existing bundles.

8a) To install, remove the bumper plate provided with your lasher by removing the

two flat head screws on the front of the unit. Install the Overlash assembly in

place of the bumper plate as shown so that the side rollers are in a vertical

position at the front opening of the machine.

If lashing wire won't pay out:

This indicates the wire isn't threaded properly. Refer to "Threading the Lashing

Wire".

NOTE: If you are unable to achieve positive drive, the lashing wire can be

threaded twice around the drive wheel.

NOTE: If using metallic wire and machine is difficult to pull, the wire can be

threaded in the opposite direction on the drive wheel. If using non-metallic

lashing wire, always thread in the standard indicated fashion.

Page | 11