Autopage CPX-2300 Dodatek do instrukcji instalacji i obsługi - Strona 2

Przeglądaj online lub pobierz pdf Dodatek do instrukcji instalacji i obsługi dla Alarm samochodowy Autopage CPX-2300. Autopage CPX-2300 2 stron.

Drukuj stronę

CPX-2300 OPERATION MANUAL

TRANSMITTER OPERATION:

Transmitter Button

Feature

Arm / Door lock

Button

Arm and Delete Optional Sensor

–

Button

Car Locator

Button

Panic

Button for 3 seconds

Disarm & door unlock

Button

In or Out Active/Passive mode

Button for 2 seconds

Silent arm / disarm

Button

Anti car-jacking

Button for 2 seconds

A. ACTIVE ARMING – LOCK & ARM:

1. Press

button on transmitter.

2. The siren chirps once and parking lights flash once indicating the system is now armed. The

vehicle doors will lock upon arming when interfaced with the security system.

DOOR AJAR WARNING: When you arm the system and the siren chirps 3 times, it means you

have left a door or trunk, or hood lid ajar. You should check and find out the defective protecting

point.

SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press

arm the security system, by-pass shock sensor connected to 3-pin plug. The system will chirp one

additional time to confirm the sensor bypass mode was activated. The sensor bypass feature is

programmed to activate for one arming cycle only. The security system will return to the original

program setting for the next arming cycle.

SILENT ARMING / DISARMING: Press

system. No chirp sound will be heard; arm / disarm confirmation will be through the vehicle's

parking lights only.

B. PASSIVE ARMING

This system is equipped with passive arming feature, which allows the system to arm itself in 30

seconds after the last door is closed; operation is as follows:

Turn ignition to OFF position and exit the vehicle

After all entrances are closed, the system will start counting and LED flashes for 30 sec., if you

re-open any door / trunk / hood the system will stop counting and the LED will stop flashing. It

will start re-counting again once all vehicles' entrances are closed.

After 30 seconds has elapsed, the security system will automatically "ARM". The siren will chirp

once and the parking lights will flash once.

REMOTE PASSIVE:

You can use the remote transmitter to both enter and to exit the passive mode, eliminating the

need to hand your transmitter to parking attendants or garage mechanics.

a). Press and release

button for 2 seconds. The system will enter the passive mode. One

long chirp confirms entry to the passive mode.

b). Press and release

button for 2 seconds. The system will exit the passive mode. Two long

chirps confirm exit of the passive mode.

PASSIVE DOOR LOCKING

The vehicle doors will automatically lock after passive arming cycle has been completed.

C. ACTIVE DISARMING – UNLOCK & DISARM:

Press

button on the transmitter, the siren will chirp twice and parking lights will flash twice to

indicate the security system is now disarmed. The vehicle doors will unlock when interfaced with

the security system.

TAMPER DISARMING: If the alarm has been triggered, upon disarming the system, the siren will

chirp 4 times and the parking lights will flash 3 or 4 times.

Remark

Press twice within 3

seconds.

Under arm mode

Press & hold 3 seconds

Press & hold 2 seconds

Under ignition off

Under ignition on

button twice within 3 seconds to

button together to arm or disarm your security

AUTO RE-ARM: The security system will auto re-arm itself within 30 seconds after disarming by

remote transmitter. Auto re-arm will be canceled if any protected door has been opened before the

30 seconds timer has elapsed.

PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case of

emergency.

1. Under the arming mode press and hold

button for over 3 seconds. The siren will sound and

the parking lights will flash.

To stop the panic mode press

button and the panic mode will turn off immediately.

If the button is not pressed, the alarm will automatically stop in 30 seconds.

D. TRIGGER THE SYSTEM

When the alarm system is armed, your vehicle is protected as follows:

Light impact will trigger the warn-away signal. A long chirp from siren.

Heavy impact / Door open / Hood open / Trunk open / Turning on the ignition switch; all will

trigger the programmed sequence.

For above (2) The siren and parking light will turn on, alerting of an intrusion for 30 seconds. Then

it will stop and automatic reset / re-arm. If any one of the sensors or detectors is still active, the

alarm system will sound a maximum of 3 times of 30 seconds cycles. The starter disable relay (if

installed) prevents the vehicle's starter from cranking.

E. ANTI CAR - JACKING

Warning: If you don't need anti car-jacking function in this alarm system, be sure to set anti car-

jacking feature "DISABLE". This system is default setting all anti car-jacking " DISABLE ".

1). With the Ignition "on", press and hold

The parking light will turn on for 2 seconds to indicate activation of anti car – jacking mode.

2). TRIGGER THE ANTI CAR - JACKING MODE:

3-timer circuits will function as follows:

First timer:

50 seconds after the system has been triggered, the siren will start chirping for 15 seconds.

During this 15 seconds period of chirping, you will be alerted to press and hold

the transmitter for over 2 seconds to turn off the anti car-jacking feature; parking lights will flash

twice and siren will chirp twice confirming success in turning off the anti car-jacking mode.

If not, it will enter the second timer of anti car- jacking feature

Second timer:

65 seconds after the system has been triggered. The siren start sounding and the parking lights

will start flashing.

Third timer:

90 seconds after the system has been triggered

a. The siren will continue sounding and the parking lights flashing, and

b. The starter disable will activate to prevent vehicle from starting.

c. It will remain active until the vehicle's battery power exhausted.

F. DISARMING WITHOUT A TRANSMITTER

The Override function may be used if the remote transmitter is lost or inoperative.

1. Turn ignition switch to 'ON' position and the LED will start flashing, indicating the system has

entered the password override mode.

Once the LED has flashed the same number of times as your password number, then turn the ignition

key "OFF"; the alarm will stop sounding and enter the disarm mode. You can now start and operate

the vehicle normally.

Example: If your programmed Password Code is " 5 " you would;

Turn the ignition switch to the 'ON' position and the LED will start flashing, indicating the system

has entered the password override mode.

Wait until the LED flashes for the 5th time, then the turn ignition key OFF immediately.

The alarm will stop sounding and enter the disarm mode. You can now start and operate the

vehicle normally.

G. IGNITION CONTROL DOOR LOCK.

If the vehicles' door locks have been interfaced to the security system, the system will

automatically lock the vehicle's door when the ignition "ON" and unlock vehicle's door when

ignition "OFF".

button on the transmitter for over 2 seconds.

button on

H. CAR LOCATOR

Under the armed mode press

button to activate car locator,

siren will chirp 6 times and parking lights flash 12 times for

you to easily locate your car.

LED INDICATORS:

LED

Function

Off

Disarmed

Slow flash

Armed

Fast flash

Passive arming

CHIRP INDICATORS:

Chirp

Function

1 chirps

Arm

2 chirps

Disarm

3 chirps

Door ajar warming

4 chirps

Disarm / shock sensor trigger

6 chirps

Car locator

PARKING LIGHTS:

Parking light

Function

1 flash

Arm

2 flashes

Disarm

3 flashes

Disarm / trigger on ignition or door

pin switch

4 flashes

Disarm / trigger on shock sensor

12 flashes

Car locator

ALARM OPERATION CONDITIONS:

Siren

Parking

LED

Door

Light

Arming

1 or 3

1 Flash Slow

Locking

Chips

Flash

Disarming

2 or 4

2 or 3 or

Off or

Unlocking Off

Chirps

Fast

Flashes

Flash

Trigger

Alarming Flashes Slow

Flash

Panic

Alarming Flashes Slow

Flash

Starter

"CUT"