Autopage MA-200 Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Alarm samochodowy Autopage MA-200. Autopage MA-200 8 stron. 2-way remote control motorcycle alarm
Również dla Autopage MA-200: Instrukcja obsługi (13 strony)

Drukuj stronę

6. Press and hold the

the unit is ready to accept adjustments of the "warn-away" sensitivity.

7. Press and hold

button on the transmitter for 2 seconds. [2] LED flash, [2] siren/horn chirps to

indicates the unit is ready to accept the adjustments of the shock sensor.

8. Pressing the

button on the transmitter once will decrease sensitivity level by one, each time an

decrease is made the siren/horn chirp will respond number of chirp which indicates level of

sensitivity.

9. Pressing the

button on the transmitter once will increase sensitivity level by one, each time an

increase is made the siren/horn chirp will respond number of chirp which indicates level of

sensitivity.

10. Hit the tank or strong metal part of the motorcycle to test the threshold level of the sensor.

a). Activate the warn-away (first stage the shock sensor), the siren/horn will emit a short chirp.

b). Activate the full alarm (second stage the shock sensor), the siren/horn will emit a long chirp.

11. When you are satisfied with the setting, press the

Note: If 20 seconds of inactivity expire, or the

steps, the unit will exit the program mode and return to the disarmed mode. 3 long chirps will

confirm exit.

Power Save Mode for Motorcycle's Power:

If the motorcycle has not been driven within 12 hrs or the security system has not been activated by

remote control within 12 hrs, the security system will automatically go into power save mode. While in

power save mode the security system will stay on at low current to save the motorcycle's battery power.

When the system is in power save mode, all remote control function are bypassed, however the ignition

trigger / wire loop trigger / instant trigger / shock sensor (PS#2) trigger / starter interrupt feature will remain

operational.

EXIT THE POWER SAVE MODE:

Turn the ignition switch to ON then OFF to exit the power save mode.

Return To Factory Default Setting:

1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.

2. Push the Valet switch 12 times and hold in on the 12

then release the valet switch. You are now in the "Return To Factory Default Setting" programming

mode.

3. Press the

and

buttons at the same time on the transmitter together for 6 seconds, there will be a confirmation of six chirp

with 3 long chirp to confirm the system "Alarm Feature" all have returned to their factory default settings.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

960 Knox Street Unit B, Torrance, CA 90502

Tel: (310) 323-1800 or (800) 262-2527 www.autopageusa.com

MA200 IN REV.A

buttons on the transmitter for 2 seconds. 2 long siren chirps will indicate

button one time to lock in the adjustment.

button on the transmitter is pressed during of above

push until six chirps and a long chirp is heard

Oct/23/2006