Autopage RF-1055KE Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Alarm samochodowy Autopage RF-1055KE. Autopage RF-1055KE 2 stron. Part 1
Również dla Autopage RF-1055KE: Programowanie nadajnika (1 strony)

Drukuj stronę
9)
PARKING LIGHT INDICATORS
PARKING LIGHTS
Operation
1 Flash + 10 sec on
Locked / The parking lights will remain "on" for 10 seconds
2 Flashes + 30 sec on Unlocked / The parking lights will remain "on" for 30 seconds
Continuous Flash
Panic Mode Engaged (30 Sec.)
10)
STARTER INTERRUPT CIRCUIT (OPTIONAL)
The vehicles starter circuit may be interrupted for additional protection when the System is
locked. Use of the RK-1 Starter Interrupt Relay kit is recommended.
11)
TRANSMITTER PROGRAMMING
In the event, you should need to add or replace a Remote Control Transmitter, it is
important that you follow the instructions below.
Note:
Each step must be performed within 10 seconds of the previous step otherwise the System
will exit the programming mode.
1.
Enter:
a.
Turn the vehicles ignition to the "ON" position
b.
Push the valet switch 3 times. There will be 1 long chirp and 1 short chirp
c.
You are now ready to program the Remote Control Transmitter(s).
2.
Programming the Remote Control Transmitters:
a.
Press any button on the first transmitter. There will be 1 short chirp.
b.
Within 10 seconds push any button on the second transmitter. There will be 2 short chirps.
3.
Exit:
a.
Turn the vehicles ignition key to the "OFF" position, Or
b.
Leave for 10 seconds; there will be 3 long chirps to confirm exit.
Note:
The Keyless Entry System will only retain the last 4 Remote Control Transmitters
programmed. If the Remote Transmitter memory is exceeded, the System will start deleting
RemoteTransmitters from memory in chronological order.
12)
SECOND VEHICLE TRANSMITTER PROGRAMMING
Your AutoPage Keyless Entry System's Remote Control Transmitter can be utilized to
control a second vehicle equipped with an RF1055KE, RF-305 or RF-405.
All programming parameters will be the same except for the following:
1.
Prior to pushing any button on the Remote Control Transmitter. Select the Green side shift
button first.
2.
While the LED is illuminated, press any button on the Remote Control Transmitter.
Note:
The System will only learn up to 4 remote transmitters.
13)
SECOND VEHICLE OPERATION
Your AutoPage Keyless Entry Systems Remote Control Transmitter can be utilized to
control a second vehicle equipped with an RF-1055KE. If your Remote Control Transmitter
is programmed to a second vehicle, the remote transmitter will operate as follows:
1.
Push the Green side shift button on the right side of the Remote Transmitter, the System LED
will illuminate for 3 seconds.
2.
While the System LED is illuminated, push the desired button operation. For Expample: To
Lock the second vehicle, simply push the Green side shift button once then push the Lock
button while the LED is illuminated.
14)
AUXILIARY FUNCTION (OPTIONAL
You may use the CAR button on your Remote Control Transmitter for a separate function.
For example, if your vehicle is equipped with an elec tronic trunk release, the Keyless Entry
System can be interfaced with it and can electronically release your trunk by pressing the
CAR button on the Remote Control Transmitter.
Function
)
RF-1055KE
PROFESSIONAL KEYLESS ENTRY SYSTEM
OPERATIONS MANUAL
THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY