Autopage RF-503 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Alarm samochodowy Autopage RF-503. Autopage RF-503 16 stron. Remote transmitters
Również dla Autopage RF-503: Podręcznik (2 strony)

Drukuj stronę

NOTE: Any transmitters programmed to the RF-503 as described above will remain in memory during

times when certain vehicle service procedures make it necessary to disconnect the battery.

To program the RF-503 transmitters, follow the directions as written below, in their exact order!

HAVE ALL TRANSMITTERS READILY AVAILABLE.

1. Flip the VALET/OVERRIDE switch to its "ON" position.

2. Turn the ignition switch to "ON", then "OFF", then immediately flip the VALET/OVERRIDE switch

"OFF", "ON/OFF", "ON/OFF". The vehicle horn or siren will chirp one (1) time.

3. Turn the ignition switch "ON/OFF", "ON/OFF". The vehicle horn or siren will chirp (2) times. You

are now in the programming mode.

4. Press button #I on one of the remote control transmitters until the vehicle horn or siren responds with

a confirming chirp. The first transmitter is now programmed.

5. Within five (5) seconds, press button #I on the second transmitter until the vehicle horn or siren

responds with a confirming chirp. The second transmitter is now programmed.

NOTE: If the RF-503 does not receive a second transmitter code to learn within five (5) seconds, it will

automatically close the programming mode and resume normal alarm functions. If this happens, it will

be necessary to repeat steps 1 through 5 and reprogram all transmitters.

NOTE: The RF-503 can learn up to four transmitter codes. If additional, optional transmitters are to be

programmed, follow sequence 1 through 5 and continue programming.

O. PROGRAMMING THE REMOTE TRANSMITTERS FOR A SECOND VEHICLE

The RF-503 transmitters are capable of controlling separately installed alarm systems in two vehicles.

To code the RF-503 transmitters for two vehicles, follow the diagrams as shown below. Before

multiple vehicle programming can be achieved, it will be necessary to enter the programming mode for

each vehicle's alarm system.

NOTE: Program each vehicle separately. Do not enter the program mode on each vehicle at the same

time.

1. TWO VEHICLE OPERATION

VEHICLE #1

Enter the programming mode on vehicle #1 and push the I Button on the transmitter for vehicle #1. The

vehicle horn or siren will respond with a confirming chirp. Within five (5) seconds, push Button II on