DCG RA2910D Podręcznik użytkownika - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Grzałka DCG RA2910D. DCG RA2910D 20 stron. Digital oil filled radiator

Note:

The higher the power is, the quicker the desired temperature will be achieved but the power

consumption will be higher.

Lower power levels are recommended when the heater is being used for an extended period of time.

Eco mode

Press the Power/Mode button (c), until the "ECO" light turn on.

Under Eco mode, the heating power will adjust automatically when the room temperature is

approaching the setting temperature.

Example: The setting temperature is 25°C. When the room temperature is less than 22°C, the heater

will work under High power (

change to work under Medium power (

will change to work under Low power (

temperature 25°C, the heater will switch off automatically. And when the room temperature is lower

than setting temperature, the heater will switch on again under Eco mode.

Remark: if no thermostat setting, the default temperature is 23°C under Eco mode.

Thermostat setting

Desired temperature setting rang:5 °C-30 °C

1. Press the Power/Mode button (c) to set the power mode.

2. Press the thermostat button (a), the temperature digit will blink.

3. Use the "+" and "-" [b] and [e] buttons to set the desired temperature.

4. The setting temperature digit will stop blinking and the setting temperature will appear after the

desired temperature is set.

5. The heater will maintain the air temperature in the room by switching on and off automatically.

Remark: No matter under any power mode to set the temperature, after thermostat setting, the

heater will work under ECO mode only.

Note: The temperature shown on the screen is just the setting temperature.

Timer : Auto power on

Note:This function should only be set if you require the heater to be automatically turned on after

a certain period of time (1 to 24 hours from the time the function is set). Only make timer power on

setting under Stand-by mode.

1. Press the on/off power switch [F] to turn the appliance on. The light on (

appliance will be in Stand-by mode.

2. Press the Timer button(d), the light on (

3. Use the "+" and "-" buttons to set the heater operation time between 1 and 24 hours. This function

will activate once the hour digit stops blinking. The count down digits will show on the display.

MANUALE D'USO - USER MANUAL - RA2910D

). When the room temperature rises to 23°C, the heater will

). When the room temperature rises to 24°C, the heater

). When the room temperature reaches to the setting

) will turn on, and the start hour digit (0.0) will blink.

dcg16.it

) will turn on. The