High Tech Pet Products BLUEFANG X-22 Podręcznik instalacji, obsługi i szkolenia - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik instalacji, obsługi i szkolenia dla Produkt do pielęgnacji zwierząt domowych High Tech Pet Products BLUEFANG X-22. High Tech Pet Products BLUEFANG X-22 16 stron. Super electronic dog fence

Drukuj stronę

______________________________________________________________________________________

High Tech Pet Products, Inc.

Crossing a Driveway or Walk

joint into which you can place the wire. Remove any calking material in the

joint, place the wire and re-caulk. If an expansion joint is not available, you

can make a ½ inch deep narrow slit across the drive or walk using a circular

power saw and masonry blade. Place the wire in the slit and seal with

outdoor silicone caulk of matching color. Use asphalt sealant for asphalt

driveways. Another option is High Tech Pet's new optional Driveway Traverse

Strip, which easily crosses driveways and walks with your electronic fence

wire. This durable rubber slit attractively covers and protects the pet fence

wire. You can drive over it, walk over it, even mow over it with no damage

to the underlying boundary wire. Made of super durable elastomer, that will

last years and years, it takes only minutes to install. To order, go to www.

hightechpet.com and search "driveway traverse strip".

Crossing Gravel

When crossing gravel, run the wire through a hose or PVC pipe and then

bury at least three inches deep.

Crossing Water

To cross a stream or body of water, run the wire through a hose or PVC pipe.

Anchor each end using large rocks or other stationary objects.

STEP 9: Place the Boundary Flags

perimeter. This is especially important during training. Flags should be

placed along the entire perimeter spaced no more than ten feet apart. Using

a fully matching color. Use asphalt sealant for asphalt driveways.

STEP 10: Fit the Receiver Collar to Your Dog

A. For the receiver collar to properly apply the corrective shock

stimulus, it is very important that the electrodes make good contact

with the animal's skin. Fur between the electrodes and skin can

greatly reduce the amount of stimulus transmitted to your dog. For

this reason, we recommend that you shave the fur under your dog's

neck where the electrodes contact the skin.

B. Place the collar around your dog's neck with the receiver housing at

the bottom.

Fit the strap as snugly as possible without restricting breathing.

D. Make sure both electrodes are in good contact with your dog's skin.

Use of a little skin lotion on your dog's neck will improve contact.

the excess length.

___________________________________________________________________________________________

High Tech Pet Products, Inc.