Dynasty VRLA Series Podręcznik - Strona 19

Przeglądaj online lub pobierz pdf Podręcznik dla Akcesoria do kamer Dynasty VRLA Series. Dynasty VRLA Series 19 stron. Valve regulated lead acid battery 20 to 200 ampere-hour capacity

Drukuj stronę

Optional

Battery

Tests and Checks

While not a requirement

of the warranty registration

the following checks are recommended

to assure

maximum reliability of the battery system over time.

After the battery system has been on "float"

for

approximately

24 hours, the float current acceptance

should be approximately

to .005 amperes or less per

rated ampere hour capacity of the battery string but

greater than zero.

The individual battery float charging voltages should

be within the following range:

1. "High rate momentary

load" test as described

in the pamphlet "Integrity Testing" Form #41- 7264,

While this test does not indicate the actual

capacity of the battery it does indicate it is

functional.

12 volt batteries

13.3 min. to 14.5 max.

10 volt batteries

11.10 min. to 12.1 max

6 volt batteries

6.65 min. to 7.25 max.

4 volt batteries

4.43 min. to 4.85 max.

2. Individual battery measurements

of resistance/

conductance/impedance

as described

in the

pamphlet "Impedance

and Conductance

Testing" Form #41- 7271. Again, while this test does

not indicate the actual capacity of the battery

it does provide base line data from which

changes can be trended over time as the

battery normally deteriorates. This can be very

useful in trouble analysis during the periodic

maintenance

activities.

Document the results of these measurement

activities

in Section VI, Float Charging Checks, of the

"Operational

Qualification

and Warranty Registration

Checklist", Form #41-7471.

If any special battery monitoring equipment

is to be

utilized, it should be installed and calibrated at this

time.

The DYNASTY battery system installation

is now

complete and the system is available for acceptance

testing and operational

service.

3. Battery performance

test as described

in the

pamphlet "Acceptance

and Performance Testing'

Form #41-7135.