Autoplugin RCP-FM Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Moduły GSM/GPRS Autoplugin RCP-FM. Autoplugin RCP-FM 12 stron.

Button function
Heater immediate
start
Heater immediate
stop
One-time boost
disable
One-time boost
enable
The fuel fired heater needs about 3 minutes to go to the normal operation after the
startup. If your trip is planned to be shorter, it is recommended to use function
called "one-time boost disable". This preserves the heater from premature
clogging. Turn on the ignition, press the button, then start the engine. Now the
heater will not operate with the engine while don't you enable boost heat mode
again.
Connection
RCP may be connected in two ways. Plug-n-play connection is easy type of
connection which not requires special skills. Permanent connection is
recommended for professional installation. It needs at least some experience in car
electronics. Read installation manual for detailed connection schemes.

Additional Functions

By default RCP is adjusted to execute basic functions, such as start of the heater by
using Ford key or additional button, stop of the heater by using the button, control
of boost heat mode, etc. To turn on additional functions (a possibility to stop the
heater by using Ford key, battery monitoring, indication by turn signals in rear-
view mirrors, extended control of boost heat mode, etc.) you need enter the module
into programming mode and activate corresponding setting.
Programming button and the brakes pedal are used to enter programming
mode and to the settings change. Plug-n-play cable is equipped with preinstalled
Ignition
Engine
status
status
Off
Not running Off
Off
Not running On
On
Not running Off
On
Not running On
On
Running
4
Heater
Description
status
(how to use)
One-touch heater start
One-touch heater stop
Quick disabling of boost
heat mode for short trips
Quick enabling of boost
heat mode in case of boost
heat mode disabling by
RCP settings or in case of
Off
one-time disabling
previously
Table 1