Galileo G-80DB Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Teleskop Galileo G-80DB. Galileo G-80DB 12 stron.

ELECTRONIC RED DOT FINDER

TO MOUNT:

1) REMOVE ELECTRONIC RED EOT FINDER FROM BOX.

2) LOOSEN THUMB SCREWS ON SIDE OF FINDER AND SLIDE FINDER ONTO DOVETAIL

MOUNT LOCATED AT TOP OF MAIN TELESCOPE TUBE.

3) TIGHTEN THUMB SCREWS.

TO CHECK ALIGNMENT WITH MAIN TELESCOPE:(IMPORTANT!)

1) THE

RED EOT

ELECTRONIC FINDER IS NOT PRE-SET AT FACTORY. THE FOLLOWING

WILL ALLOW YOU TO ADJUST THE ALIGNMENT.

2) DURING THE DAY LIGHT HOURS, AIM THE MAIN TELESCOPE AT AN OBJECT AT LEAST 1/4

MILE OR MORE IN THE DISTANCE AND BRING IT INTO FOCUS.(VERY IMPORTANT)

3) ONCE YOU HAVE CENTERED THE REFERENCE ITEM IN THE MAIN TUBE, TIGHTEN ALL

KNOBS AND ADJUSTMENTS TO PREVENT ANY MOVEMENT.

4) REMOVE CIRCULAR B ATTERY S AVER L OCATED B ENEATH F RONT O F F INDER (B E S URE.

TO SAVE AND REPLACE THE BATTERY SAVER WHEN NOT IN USE.)

5) TURN FINDER ON B Y S LIDING O N/OFF S WITCH F ORWARD. O N/OFF S W ITCH IS LO CATED

ON THE RIGHT SIDE OF THE FINDER.

6) LOOK THROUGH THE FINDER AND LOCATE

THE RED DOT.

7) IF THE OBJECT IN THE

MAIN TELESCOPE TUBE, ADJUSTMENT IS REQUIRED.

8) TO MOVE THE RED DOT UP AND DOWN, SIMPLY TURN THE ELEVATION SCREW LOCATED

ON THE REAR BOTTOM OF THE FINDER TO HEIGHT REQUIRED.

9) TO MOVE THE RED DOT LEFT AND RIGHT, SIMPLY TURN THE WINDAGE SCREW LOCATED

AT THE FRONT LEFT SIDE OF THE FINDER TO THE PROPER POSITION.

10) THESE ADJUSTMENTS WILL ALLOW YOU TO POSITION THE RED DOT ON THE SAME

OBJECT CENTERED IN THE MAIN TELESCOPE.

MOUNTING & ALIGNMENT

RED EOT

FINDER IS NOT THE OBJECT YOU SEE THROUGH THE