Dynatech BBM Dodatkowe instrukcje dotyczące konserwacji i napraw - Strona 3

Przeglądaj online lub pobierz pdf Dodatkowe instrukcje dotyczące konserwacji i napraw dla Piła Dynatech BBM. Dynatech BBM 10 stron. Mini masonry saw

BBM & YBM INSTRUCTIONS [May 2004]

Removing the Motor [Continued]

7. Using a Phillips head screw driver, remove the four

screws in the back of the plastic motor air intake

cover and slide the housing outward and off of the

motor housing.

8. Using a coin or a wide blade screw driver, remove

the plastic brush cap and carefully pull the carbon

brush out of the motor housing. Remove brushes

on both sides before attempting to pull the motor

housing off of the armature.

9. Using a Phillips head screw driver, remove the four

screws at the front of the motor housing and

carefully slide the motor housing outward and off

the armature.

10. Pull the plastic motor retaining plate out of the cutting head casting

and off the armature.

11. Grab the armature and pull the armature outward and out of the

motor housing.

If the armature does not pull out of the housing, remove the blade shaft retaining plate assembly

and use a long, wide blade screw driver and rubber mallet to tap the armature out of the cutting

head casting. Make sure to place the screw driver against the end of the armature shaft and

NOT against the radial bearing race or against the cutting head casting. Once the armature is

removed, re-insert the blade shaft retaining plate assembly into the cutting head casting. Align

the ears in the blade shaft retaining plate casting with the holes in the cutting head casting and

then insert two screws in the top ears and tighten.

NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!