Gallagher T11 Uwaga dotycząca instalacji
Przeglądaj online lub pobierz pdf Uwaga dotycząca instalacji dla Czytnik kart Gallagher T11. Gallagher T11 11 stron.
Również dla Gallagher T11: Uwaga dotycząca instalacji (11 strony), Uwaga dotycząca instalacji (13 strony)
Drukuj stronę
ATTENTION: This equipment contains components that can be damaged
by electrosta c discharge. Ensure both you and the equipment are earthed
before beginning any servicing.
The Gallagher T11 Reader
The Gallagher T11 Reader is a smart card proximity reader. It can be installed as
either an entry reader or exit reader. It can be mounted on a ver cal, rectangular
50 mm x 75 mm (2" x 3") fl ush box with moun ng holes spaced at a nominal 85 mm
(3.25").
The Mifare reader reads: Mifare DESFire EV1, Mifare Plus and Mifare Classic cards.
The Mul Tech reader reads: Mifare DESFire EV1, Mifare Plus, Mifare Classic and
125 kHz cards.
The reader sends informa on to the Gallagher Controller and acts upon informa on
sent from the Gallagher Controller. The reader itself does not make any access
decisions.
The Gallagher T11 Reader uses the "Cardax IV Reader" communica ons protocol to
communicate with the Gallagher Controller.
Note: A French transla on of this document can be downloaded from the Gallagher
Support Site: h p://support.gallagher.co
IMPORTANT: Gallagher T11 Mul Tech readers only:
Using dual technology 125/Mifare cards with Gallagher T11 Mul Tech readers
may cause both card technologies to be read, resul ng in double card badges
and unusual reader feedback. Gallagher strongly recommends against using dual
technology 125/Mifare cards with Gallagher Mul Tech readers for sites running
pre-Command Centre v7.00 so ware (due for release 2nd half, 2011). From
Command Centre v7.00, a site may specify which technology a Mul Tech reader
should read off a dual technology card.
Part Number: 3E2513 | Edi on 10
November 2012
Installa on Note
Gallagher T11 Reader
Page 1