Adept Audio IO60W Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Głośniki Adept Audio IO60W. Adept Audio IO60W 8 stron. Indoor /outdoor speakers
Indoor/Outdoor Speakers Installation Manual
Speaker Placement
The IO50, IO60 and IO80 can be placed vertically or horizontally, indoors or outdoors. The included bracket allows the
speaker to swivel, in order to better direct the sound to the listeners. For a small seating area, two speakers will probably
be enough, but getting consistent coverage over multiple seating areas or an entire backyard will require additional pairs
of speakers. Typically, placing a pair of speakers so that the speakers are about 8 to 12 feet apart and equidistant from
the main listening seat will give the best results.
Mounting the Speakers
Make sure that the bracket is securely mounted onto a structurally sound surface that can support the weight of the
speaker and bracket, and will not be affected by vibrations coming from the speaker. In general, a screw size of #8 by 2
inches or M4 by 50mm is recommended.
INDOORS: It's best to install the mounting screws directly into wall studs. Drywall anchors can also be used when mount-
ing into studs is impractical, but make sure the anchors are heavy-duty models rated for at least double the weight of the
speakers.
OUTDOORS: If the speakers are attached to eaves, wood roofing or wood fences, the mounting screws can be driven
directly into the material. If mounting the speakers on stucco or masonry walls, use masonry anchors rated for at least
double the weight of the speakers.
Installing the Speakers
When you've decided on the locations for all of the speakers, remove the bracket from each speaker. Use a pencil to
mark inside the mounting bracket holes so you can tell where the holes will be when you drill. You may wish to use a
bubble level along the edge of the bracket to make sure the speaker is level.
Drill a hole where each mounting bracket screw or drywall or masonry anchor will go, using a drill bit of the recommend-
ed size for the screw or anchor you are using. If you're using anchors, place the anchors in the holes. Now align the
bracket with the mounting holes, insert the screws, and tighten them firmly. Put the speaker in the bracket, and install the
threaded mounting knobs in each end of the speaker and tighten them enough to secure the speaker in the bracket.
5