AgroMax AM250 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna AgroMax AM250. AgroMax AM250 2 stron. Submersible water pumps

Drukuj stronę

INTRODUCTION

AgroMax® pumps are carefully inspected and tested to ensure both safety and

operating performance. PLEASE NOTE: Failure to follow the instructions and warnings

in this manual may result in pump damage and/or serious injury. Be sure to read and

save this manual for future reference.

WARNING

• This pump is equipped with a grounding connector and grounding type electrical plug.

To reduce risk of electric shock, connect to a properly grounded outlet.

• Do not remove cord and strain relief.

• This pump has been evaluated for use with water only.

• Ensure the unit is properly grounded. Do not remove the grounding pin.

• Only connect the pump to a 120v outlet.

• Always disconnect from electrical outlet before handling the pump.

• The NFPA NEC (National Electrical Code) Article 680 (Fountains) states that

submersible pumps require a Ground Fault Circuit Interrupter (GFCI or GFI) listed for

personnel protection is installed. Provide proper GFCI protection on installation.

• Do not use these pumps in water over 100º F (38º c).

• Operate pump completely submerged for proper cooling.

• Do not let the pump run dry.

• Do not lift the pump by the power cord.

PERFORMANCE

• A clogged or dirty intake screen will greatly reduce the performance of the pump.

• If the pump is used on a dirty surface, raise it slightly to reduce the amount of debris

contacting the intake.

• If less flow is desired, adjust the flow control lever on the side of the pump or restrict

the discharge flow.

• Do not let the pump run when not submerged in water. Doing so may damage the

pump. Always submerge the pump first, and then plug into the electrical outlet.

• At first, the pump may not pump water; this is caused by existing air in the pump and

tube. To start the flow, you may need to plug and unplug several times and the pump

will start pumping water.

MAINTENANCE

• To clean the pump, remove front cover and the impeller. Use a small brush and a

stream of water to remove debris. Do not remove the pump shaft.

IF THE PUMP FAILS TO OPERATE

• Check the circuit breaker or try another outlet to ensure pump is getting electrical

power. NOTE: Always disconnect from electrical outlet before handling the pump.

• Check the pump discharge and tubing for kinks and obstructions. Any algae or debris

buildup should be flushed out.

• Check the inlet screen to ensure it is not clogged with debris.

• Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not

broken or jammed.

• Monthly maintenance will add to the pump's life. NOTE: Ensure that the electrical

cord loops below the electrical outlet to form a "drip loop", this will prevent water from

running down the electrical cord and into the electrical outlet.

AM160 PUMP

REGULATOR

FRONT COVER

AM250 PUMP

AM400 PUMP

SHAFT COVER

WATER LEAVE SEATING

SEALING RING

IMPELLER HOLDER

FILTER COVER

SHAFT

IMPELLER

PUMP BODY

IMPELLER HOLDER

SUCTION CUPS

WATER OUTLET

SEALING RING

PUMP BODY

SHAFT

IMPELLER

SUCTION CUPS

SUCTION CUPS HOLDER