DCS CT-365SS Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Okap wentylacyjny DCS CT-365SS. DCS CT-365SS 20 stron. Professional 5 burner 36” drop-in cooktop
Również dla DCS CT-365SS: Instrukcja obsługi i konserwacji (18 strony), Instrukcja instalacji (15 strony)
Drukuj stronę
INSTALLATION INSTRUCTIONS
PREPARING FOR THE INSTALLATION:
Be sure to read page 6 for the proper ventilation
requirements
before you begin.
When making your CUTOUT refer to page 8-9 for cabinet preparation.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Unpack the unit, the regulator, and remove a[[ packing
between
a[[ the burners, rings,
and caps. Remove the grates from their boxes.
With the necessary tooHs and hardware
ready, measure the distance from the back and
sides of the countertop
and cabinet to locate the position
of the cooktop Cutout.
Make your Cutout according
to the dimensions
given on page 8 & 9. Square the cutout
to the countertop.
Lower the cooktop
into the countertop
cutout,
being
carefu[
not to damage
the
counter, inHet pipe threads, or the power cord of the cooktop.
Square the cooktop
to the cutout and install[ the (4) retaining
brackets onto the 8 holies
for CT-365 and (2) retaining
brackets onto 4 holies for CT-304 [ocated at the bottom
of
the unit (See Figure 1 bellow), ff hoHd down brackets are not instaHHed,the cooktop
wH[
not pull[ down to countertop.
Tighten
the 4 preHoaded thumb
screws which wH[ keep the unit secured. Do Not Over-
tighten
(See Figure 2 detail below).
NOTE: Some installations
may not have adequate
clearance at the front for the "Z'-shaped retain-
ing bracket. In those cases, use the "E-bracket provided.
Fasten the bracket to the bottom
of
the cooktop
chassis using one of the screw holes provided
for the retaining
brackets. Make
sure the bracket extends out far enough to con tact the inside of the cabinet face. While push-
ing down on the front edge of the cooktop
from above, attach the bracket to the cabinet.
This step wil insure that the edge of the cooktop is flush with the counter surface. Plug the
adjacent
unused hole in the cooktop
chassis with a screw See Figure 3, page 8.
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
Install the regulator
with
the arrow in the direction
of the gas flow
(towards
the
cooktop)
using a sealant on the male pipe threads. Put burner rings and burner caps in
place.
Connect the gas line to the unit. Refer to page 9 for gas supply hookup.
Turn bah valve to let the gas flow. Check for gas leak.
Hug the unit into a wail outlet.
Turn the front burner knob on first and apply a match to the burner until the gas lights,
being cautious
not to burn your hand or other parts of your body.When
the gas is first
activated, there is air present in the gas lines.The match applied to the burner makes it
easier and safer to dear the air/gas mixture. Use Caution to avoid burn injury.
Put grates in place.
Bracket (p/n 91164)
Screw (p/n 15117-02)
F/G_ 1
["[
,..L:'-.,
Screw (p/n 15001-22)
FIG_2