AFINIA LABEL L901 Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarka AFINIA LABEL L901. AFINIA LABEL L901 7 stron.
Drukuj stronęStep 6
Install Printhead
Handle Printhead with extreme care to avoid
damage.
CAUTION
Use electrostatic discharge (ESD) protection
when handling Printhead.
Hold Printhead by handles ONLY.
DO NOT touch ink couplings, nozzle surface
or electrical contacts.
DO NOT unpack Printhead until Printer is
ready for installation. Once unwrapped, delay
in installing Printhead can compromise print
quality.
DO NOT place an unwrapped Printhead on any
surface before installing. Protect Printhead
from scratches, dust, fibers, dirt and other
contaminants at all times.
1. Open the Top Cover. Print
head latch should be in the
open positon. If not, on the
Touchscreen open the
Service dropdown from
Menu. Press Release
Printhead. Printer runs,
then Latch [1] pops open.
NOTE: Remove Cap
Protectors [2] on Ink
Nozzles. Be sure to open
Latch fully to retract Ink Nozzles.
CAUTION
DO NOT PRY OR MANUALLY LIFT PRINTHEAD
LATCH OR LATCH MAY BREAK.
ONLY OPEN LATCH USING THE RELEASE
PRINTHEAD BUTTON ON THE TOUCHSCREEN
OR IN THE PRINTER TOOLBOX.
2. Carefully remove Printhead from foil
packaging (A) and orange cover (B)
3. Remove protective tapes
Remove the protective tapes covering the
contacts (C) and print nozzles (D). Do not lift
the tape from the nozzles at less than a 45
angle.
Take care not to damage copper contacts,
metal plate, or gold Printhead surface.
4. Carefully insert Printhead into compartment at
an angle (as shown) [4]. Once seated, gently tilt
Printhead back until it snaps into position [5].
DO NOT FORCE Printhead into position.
Page 6