DCS EH-36SS Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Okap wentylacyjny DCS EH-36SS. DCS EH-36SS 16 stron. The professional euro vent hood
Również dla DCS EH-36SS: Instrukcja użytkowania i instalacji (18 strony), Instrukcja obsługi i konserwacji (11 strony), Instrukcja obsługi i konserwacji (7 strony), Instrukcja instalacji (14 strony)

Drukuj stronę

SAFETY PRACTICES & PRECAUTIONS

This Euro Hood system is designed

to remove smoke, cooking

vapors and odors from the cooktop

area.

WARNING:

ALL WALL AND FLOOR OPENINGS WHERE THE Euro Hood IS iNSTALLED MUST

BE SEALED.

ConsuHt the cooktop

or range instaHHation instructions

given by the manufacturer

before making any

cutouts.

MOBHLE HOME HNSTALLATHON-The instaHHation of this Euro Hood

must conform

to the

Manufactured

Home Construction

and Safety Standards, TitHe 24 CFB, Part 3280 (formerHy FederaH

Standard for Mobile Home Construction

and Safety, TitHe 24, HUD, Part 280). Three wire power suppHy

must be used and the appHhnce wiring

must be revised. See EHectricaHRequirements

(page 5).

[] Venting system MUST terminate

outside the home.

[] DO NOT terminate

the ductwork

in an attic or other encHosed space.

[] DO NOT use 4" Haundry-type waHH caps.

[] FHexibHe-type ductwork

is not recommended.

[] DO NOT obstruct

the flow of combustion

and ventiHation air.

[] FaiHure to foHHowventing

requirements

may resuHt in a fire.

[] EHectricaHground is required on this Euro Hood.

[] HfcoHd water pipe is interrupted

by pHastic, non-metaHHic gaskets or other materiaHs, DO NOT us

for grounding,

[] DO NOT ground

to a gas pipe.

[] DO NOT have a fuse in the neutraH or grounding

circuit.

A fuse in the neutraH or grounding

circuitcouHd resuHt in eHectricaHshock.

[] Check with a quaHified eHectdcian if you are in doubt as to whether

the Euro Hood is properHy

grounded.

[] FaiHure to foHHoweHectricaHrequirements

may resuHt in a fire.

WARNING:

TO REDUCE THE RiSK OF FIRE, ELECTRICAL SHOCK, OR iNJURY TO PERSONS,

OBSERVE THE FOLLOWING:

Use this unit only in the manner intended

by the manufacturer.

Hfyou have any questions, contact the

manufacturer.

Before servicing or cHeaning unit, switch power offat service pane[ and Hockthe service

disconnecting

means to prevent

power from being

switched

on accidentaHHy. When the service

disconnecting

means cannot be [ocked, secureHy fasten a prominent

warning

device, such as a tag, to

the service panel

HnstaHHationWork And EHectdca[ Wiring

Must Be Done By QuaHified Person(s) Hn

Accordance

With AM[AppHicabHe Codes And Standards, HncHuding Fire-Rated Construction.

Sufficient

air is needed for proper

combustion

and exhausting

of gases through

the flue (chimney)

of fue[

burning equipment

to prevent backdrafting.

FoHHow the heating equipment

manufacturer's

guideHine

and safety standards such as those pubHished by the Nationa[ Fire Protection

Association

(NFPA),and

the American

Society for Heating, Refrigeration

and Air Conditioning

Engineers (ASHRAE), and the

[oca[ code authorities.

When cutting

or driHHing into wall[ or ceiHing, do not damage

eHectrica[ wiring

and other hidden utiHities.

NOTE: Ducted fens must elweys be vented to the outdoors.