Gallet CRO 615 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenia kuchenne Gallet CRO 615. Gallet CRO 615 6 stron.
Drukuj stronę
USE OF THE APPLIANCE:
– T he appliance is intended for home use and similar (in shops, offices and similar
workplaces, in hotels, motels and other residential environments, in facilities providing
accommodation with breakfast). It is not intended for commercial use!
– Never immerse the appliance into water (even its parts)!
– The appliance must not be used in damp or wet environment and in any environment with
the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and
other flammable or volatile materials are stored).
– W hen handling the appliance, use the handle.
– U se the appliance in the working position only at places with no risk of turning over and in
sufficient distance from heat sources (e.g. heater, stove, cooker, oven, grill), flammable
objects (e.g. curtains, drapes, etc.) and wet surfaces (e.g. sinks, wash basins, etc.).
– S pontaneous ignition of prepared food may occur during grilling. Unplug the appliance
from the mains and put out the fire in case of sudden ignition.
– I n order to ensure safety and proper function of the appliance, use only original spare
parts and accessories approved by the manufacturer.
POWER CORD:
If the power cord of the appliance is corrupted, it has to be replaced
–
by the manufacturer, its service technician or a similarly qualified
person so as to prevent dangerous situations.
N ever use the appliance if its power cord or plug is damaged, if it
–
does not work properly, if it fell down and was damaged or if it fell to
water. In this case take the appliance to a special service to check
its safety and proper function.
– N ever put the power cord on hot surfaces or do not let it hang over the edge of a table or
a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or
drawing the appliance down and serious injury!
– T he power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A1 – hinged lid
A2 – signal lights
A3 – handle
III. PREPARATION FOR USE
Remove all the packing material and take out the toaster. Remove all possible adhesion
foils, stick-on labels or paper from the toaster. After the first putting into operation and let an
„open" toaster in operation with a window open for about 10 minutes, then turn it off and let
it cool down. After the appliance cools down, swipe the parts that come in contact with food
with a soft, wet and clean cloth or a paper towel.
IV. INSTRUCTIONS FOR USE
Place the assembled appliance on a flat, steady, smooth and clean surface at a height of at
least 85 cm. Leave enough space to ensure sufficient ventilation.
A4 – lock (locking clip)
A5 – plates
A6 – power cord
20 / 27