DCS RGSC-305 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zakresy DCS RGSC-305. DCS RGSC-305 8 stron. Lp/natural conversion kit for rgsc-305 professional range

Drukuj stronę

STEP 6

RE-ASSEMBLE SURFACE BURNERS, CHECK OPERATION

Cooktop Section

Re-assemble the burners and valve panel in the reverse order shown in Step 2 above. Make sure the brass port

rings are properly engaged in the simmer rings.

Check for proper ignition:

Connect electrical power.

Push in one control knob and turn 90° to "HI" position.

The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit. (Note

that all burners will spark.)

The first test may require some time while air is flushed out of the gas line.

Turn knob to "OFF" .

Repeat the procedure for each burner.

Check Flame Quality

Check for proper burner flame characteristics (see diagram).

Burner flames should be blue and stable. Some yellow tipping may be normal on LP Gas. The flame should not

have excessive noise or exhibit lifting of the flame from the burner. Due to differences in gas characteristics and

burner usage (i.e. gas pressure, cleanliness, etc.), burners may perform differently.

Burner Operation

Two flames are used on all five burners. These dual flame burners have an upper ring of main burner ports that

produce the main flame for high heat cooking from the "HI" knob setting to the "LO" knob setting.

The bottom simmer flame is used for simmer heat cooking operations such as melting chocolate, holding food at

serving temperature and simmering. Both flames are lit when the knob is between "HI" and "LO" . Only the simmer

flame is lit when the knob is in the "SIM" position.

Burner Adjustment

There is no air shutter adjustment, etc. on this burner.

The only adjustment available is to clean the burners and clean or replace orifices.

Simmer Ring

Burner Cap

High to Low

Flame

Simmer Flame

Main Burner Ports