DCS RGSC-305BK Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zakresy DCS RGSC-305BK. DCS RGSC-305BK 17 stron. Professional 30” self clean gas range

PLANNING THE INSTALLATION

The RGSC-305 is tested in accordance with ANSI Z21.1 Standard for Household Cooking Gas

Appliances.

The range must be installed in conjunction with a suitable overhead vent hood. (See Step 1 for

ventilation requirements, page 4). Due to the professional high heat capacity of this unit, particular

attention should be paid to the hood and duct work installation to ensure it meets local building

codes. To eliminate risk of burns or fire by reaching over heated surface units, cabinet storage located

above the surface units should be avoided.

All range models with less than a 12" clearance between combustable material and the back edge of

the range, require the installation of one of the two offered Wall Mount Backguards.

Wall Mount Full

Backguard

(Model No.

5/16"

BGS-3030)

Wall Mount

Low Backguard

(Model No.

BGS-1230)

5/16"

FIG. 1

Check local building codes for the proper method of range installation. Local codes vary. Installation,

electrical connections, and grounding must comply with all applicable codes. In the absence of local

codes, the range / cooktop should be installed in accordance with the National Fuel Gas Code ANSI

Z223.1-1988 and National Electrical Code ANSI / NFPA 70-1990.

Be sure that the unit being installed is set up for the kind of gas being used. The gas range is shipped

from the factory set and adjusted for Natural Gas or LP (propane), depending on the specific model

ordered. Verify that the range is compatible with the gas at the installation site before

proceeding further. Return range to dealer if the unit is not set for site gas supply.

1/8"

FIG. 2